Hello,
Distro: https://raspi.debian.net/ (sid)
Hardware: Raspberry Pi Zero W
Kernel version: 5.9.11 (linux-image-5.9.0-4-rpi)
To access a device connected to my pi, I need the spi0 bus, and would
like to not be doing GPIO bit-banging when there are perfectly good
spi modules capable of using the SPI alternative mode of these pins.
spi0 is declared in the vanilla devicetree for this device:
arch/arm/boot/dts/bcm2835-rpi-zero-w.dts ends up including
arch/arm/boot/dts/bcm283x.dtsi which contains:
spi: spi@7e204000 {
compatible = "brcm,bcm2835-spi";
reg = <0x7e204000 0x200>;
interrupts = <2 22>;
clocks = <&clocks BCM2835_CLOCK_VPU>;
#address-cells = <1>;
#size-cells = <0>;
status = "disabled";
};
To my new-to-devicetree eye, this looks like this is intended to be
overridden, at least with a
status = "okay";
property (although a bit more is needed).
As I believe is the correct way, I wrote a devicetree overlay doing
this and a bit more in order to enable this bus and one of its device
(the one matching the chip-select monitored by the board I connected).
To confirm that I had no typo in my symbol names I ran fdtoverlay with
the packaged device tree binary, plus my overlay, but could not get it
to work, until I took a closer look at the packaged device tree and
realised it lacks a __symbols__ section.
So I pulled the source, added "-@" to the cmd_dtc rule in
scripts/Makefile.lib, built the dtb, tested fdtoverlay against it and
voila, it worked. I could then reboot with this devicetree, load my
overlay and use spi0 with no further change.
So now I wonder why this option is not enabled while there are these
sections which seem to not be usable without an overlay ?
And further, why it does not seem to be possible to enable with a
kernel config option ?
I must be missing something obvious, but I'm still failing to see it.
Regards,
--
Vincent Pelletier
