From: Stefan Agner <[email protected]>
[ Upstream commit 656ab1bdcd2b755dc161a9774201100d5bf74b8d ]
According to the datasheet (Rev. 1.9) the RTL8211F requires at least
72ms "for internal circuits settling time" before accessing the PHY
registers. On similar boards with the same PHY this fixes an issue where
Ethernet link would not come up when using ip link set down/up.
Fixes: a2c6e82e5341 ("ARM: dts: meson: switch to the generic Ethernet PHY reset
bindings")
Reviewed-by: Martin Blumenstingl <[email protected]>
Tested-by: Martin Blumenstingl <[email protected]> # on
Odroid-C1+
Signed-off-by: Stefan Agner <[email protected]>
Signed-off-by: Kevin Hilman <[email protected]>
Link:
https://lore.kernel.org/r/ff78772b306411e145769c46d4090554344db41e.1607363522.git.ste...@agner.ch
Signed-off-by: Sasha Levin <[email protected]>
---
arch/arm/boot/dts/meson8b-odroidc1.dts | 2 +-
arch/arm/boot/dts/meson8m2-mxiii-plus.dts | 2 +-
2 files changed, 2 insertions(+), 2 deletions(-)
diff --git a/arch/arm/boot/dts/meson8b-odroidc1.dts
b/arch/arm/boot/dts/meson8b-odroidc1.dts
index a24eccc354b95..0f9c71137bed5 100644
--- a/arch/arm/boot/dts/meson8b-odroidc1.dts
+++ b/arch/arm/boot/dts/meson8b-odroidc1.dts
@@ -219,7 +219,7 @@
reg = <0>;
reset-assert-us = <10000>;
- reset-deassert-us = <30000>;
+ reset-deassert-us = <80000>;
reset-gpios = <&gpio GPIOH_4 GPIO_ACTIVE_LOW>;
interrupt-parent = <&gpio_intc>;
diff --git a/arch/arm/boot/dts/meson8m2-mxiii-plus.dts
b/arch/arm/boot/dts/meson8m2-mxiii-plus.dts
index d54477b1001ca..84b6ed51099db 100644
--- a/arch/arm/boot/dts/meson8m2-mxiii-plus.dts
+++ b/arch/arm/boot/dts/meson8m2-mxiii-plus.dts
@@ -83,7 +83,7 @@
reg = <0>;
reset-assert-us = <10000>;
- reset-deassert-us = <30000>;
+ reset-deassert-us = <80000>;
reset-gpios = <&gpio GPIOH_4 GPIO_ACTIVE_LOW>;
};
};
--
2.27.0
