Add support for Intel KeemBay DMA registers. These registers are required
to run data transfer between device to memory and memory to device on Intel
KeemBay SoC.
Signed-off-by: Sia Jee Heng <jee.heng....@intel.com>
Reviewed-by: Andy Shevchenko <andriy.shevche...@linux.intel.com>
Reviewed-by: Eugeniy Paltsev <eugeniy.palt...@synopsys.com>
Tested-by: Eugeniy Paltsev <eugeniy.palt...@synopsys.com>
---
drivers/dma/dw-axi-dmac/dw-axi-dmac.h | 14 ++++++++++++++
1 file changed, 14 insertions(+)
diff --git a/drivers/dma/dw-axi-dmac/dw-axi-dmac.h
b/drivers/dma/dw-axi-dmac/dw-axi-dmac.h
index 46baf93de617..3a357f7fda02 100644
--- a/drivers/dma/dw-axi-dmac/dw-axi-dmac.h
+++ b/drivers/dma/dw-axi-dmac/dw-axi-dmac.h
@@ -63,6 +63,7 @@ struct axi_dma_chip {
struct device *dev;
int irq;
void __iomem *regs;
+ void __iomem *apb_regs;
struct clk *core_clk;
struct clk *cfgr_clk;
struct dw_axi_dma *dw;
@@ -169,6 +170,19 @@ static inline struct axi_dma_chan
*dchan_to_axi_dma_chan(struct dma_chan *dchan)
#define CH_INTSIGNAL_ENA 0x090 /* R/W Chan Interrupt Signal Enable */
#define CH_INTCLEAR 0x098 /* W Chan Interrupt Clear */
+/* These Apb registers are used by Intel KeemBay SoC */
+#define DMAC_APB_CFG 0x000 /* DMAC Apb Configuration Register */
+#define DMAC_APB_STAT 0x004 /* DMAC Apb Status Register */
+#define DMAC_APB_DEBUG_STAT_0 0x008 /* DMAC Apb Debug Status Register 0 */
+#define DMAC_APB_DEBUG_STAT_1 0x00C /* DMAC Apb Debug Status Register 1 */
+#define DMAC_APB_HW_HS_SEL_0 0x010 /* DMAC Apb HW HS register 0 */
+#define DMAC_APB_HW_HS_SEL_1 0x014 /* DMAC Apb HW HS register 1 */
+#define DMAC_APB_LPI 0x018 /* DMAC Apb Low Power Interface Reg */
+#define DMAC_APB_BYTE_WR_CH_EN 0x01C /* DMAC Apb Byte Write Enable */
+#define DMAC_APB_HALFWORD_WR_CH_EN 0x020 /* DMAC Halfword write enables */
+
+#define UNUSED_CHANNEL 0x3F /* Set unused DMA channel to 0x3F */
+#define MAX_BLOCK_SIZE 0x1000 /* 1024 blocks * 4 bytes data width */
/* DMAC_CFG */
#define DMAC_EN_POS 0
--
2.18.0
