On 2/16/2021 7:21 AM, Eli Cohen wrote:
On Thu, Feb 11, 2021 at 09:33:14AM +0200, Eli Cohen wrote:
On Wed, Feb 10, 2021 at 01:48:00PM -0800, Si-Wei Liu wrote:
While virtq is stopped, get_vq_state() is supposed to
be called to get sync'ed with the latest internal
avail_index from device. The saved avail_index is used
to restate the virtq once device is started. Commit
b35ccebe3ef7 introduced the clear_virtqueues() routine
to reset the saved avail_index, however, the index
gets cleared a bit earlier before get_vq_state() tries
to read it. This would cause consistency problems when
virtq is restarted, e.g. through a series of link down
and link up events. We could defer the clearing of
avail_index to until the device is to be started,
i.e. until VIRTIO_CONFIG_S_DRIVER_OK is set again in
set_status().
Fixes: b35ccebe3ef7 ("vdpa/mlx5: Restore the hardware used index after change
map")
Signed-off-by: Si-Wei Liu <si-wei....@oracle.com>
Acked-by: Jason Wang <jasow...@redhat.com>
Acked-by: Eli Cohen <e...@nvidia.com>
I take it back. I think we don't need to clear the indexes at all. In
case we need to restore indexes we'll get the right values through
set_vq_state(). If we suspend the virtqueue due to VM being suspended,
qemu will query first and will provide the the queried value. In case of
VM reboot, it will provide 0 in set_vq_state().
I am sending a patch that addresses both reboot and suspend.
With set_vq_state() repurposed to restoring used_index I'm fine with
this approach.
Do I have to repost a v3 of this series while dropping the 3rd patch?
-Siwei
---
drivers/vdpa/mlx5/net/mlx5_vnet.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/vdpa/mlx5/net/mlx5_vnet.c
b/drivers/vdpa/mlx5/net/mlx5_vnet.c
index 7c1f789..ce6aae8 100644
--- a/drivers/vdpa/mlx5/net/mlx5_vnet.c
+++ b/drivers/vdpa/mlx5/net/mlx5_vnet.c
@@ -1777,7 +1777,6 @@ static void mlx5_vdpa_set_status(struct vdpa_device
*vdev, u8 status)
if (!status) {
mlx5_vdpa_info(mvdev, "performing device reset\n");
teardown_driver(ndev);
- clear_virtqueues(ndev);
mlx5_vdpa_destroy_mr(&ndev->mvdev);
ndev->mvdev.status = 0;
++mvdev->generation;
@@ -1786,6 +1785,7 @@ static void mlx5_vdpa_set_status(struct vdpa_device
*vdev, u8 status)
if ((status ^ ndev->mvdev.status) & VIRTIO_CONFIG_S_DRIVER_OK) {
if (status & VIRTIO_CONFIG_S_DRIVER_OK) {
+ clear_virtqueues(ndev);
err = setup_driver(ndev);
if (err) {
mlx5_vdpa_warn(mvdev, "failed to setup
driver\n");
--
1.8.3.1
