This change will rename parameter name in macro nandc_set_read_loc().renamed parameter names are cw_offset, read_size, is_last_read_loc. Sinc in QPIC V2 on-wards there is separate location register to read last code word, so to just differnciate b/w is_last_read_loc from last_cw this change needed.
Signed-off-by: Md Sadre Alam <mda...@codeaurora.org> --- drivers/mtd/nand/raw/qcom_nandc.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/drivers/mtd/nand/raw/qcom_nandc.c b/drivers/mtd/nand/raw/qcom_nandc.c index 4189a7f..bfefb4e 100644 --- a/drivers/mtd/nand/raw/qcom_nandc.c +++ b/drivers/mtd/nand/raw/qcom_nandc.c @@ -181,11 +181,11 @@ #define ECC_BCH_4BIT BIT(2) #define ECC_BCH_8BIT BIT(3) -#define nandc_set_read_loc(nandc, reg, offset, size, is_last) \ +#define nandc_set_read_loc(nandc, reg, cw_offset, read_size, is_last_read_loc) \ nandc_set_reg(nandc, NAND_READ_LOCATION_##reg, \ - ((offset) << READ_LOCATION_OFFSET) | \ - ((size) << READ_LOCATION_SIZE) | \ - ((is_last) << READ_LOCATION_LAST)) + ((cw_offset) << READ_LOCATION_OFFSET) | \ + ((read_size) << READ_LOCATION_SIZE) | \ + ((is_last_read_loc) << READ_LOCATION_LAST)) /* * Returns the actual register address for all NAND_DEV_ registers -- 2.7.4