When there is power domain bind with bus clock, The call flow: devm_regmap_init_mmio_clk - clk_prepare() - clk_pm_runtime_get()
cause the power domain of clock always be enabled after regmap_init(). which impact the power consumption. So use devm_regmap_init_mmio instead of devm_regmap_init_mmio_clk,but explicitly enable clock when it is used. Signed-off-by: Shengjiu Wang <shengjiu.w...@nxp.com> --- sound/soc/fsl/fsl_esai.c | 48 ++++++++++++++++++++++++++++++---------- 1 file changed, 36 insertions(+), 12 deletions(-) diff --git a/sound/soc/fsl/fsl_esai.c b/sound/soc/fsl/fsl_esai.c index 41b154417b92..c0d4f3c5dbb1 100644 --- a/sound/soc/fsl/fsl_esai.c +++ b/sound/soc/fsl/fsl_esai.c @@ -945,6 +945,9 @@ static const struct regmap_config fsl_esai_regmap_config = { .cache_type = REGCACHE_FLAT, }; +static int fsl_esai_runtime_resume(struct device *dev); +static int fsl_esai_runtime_suspend(struct device *dev); + static int fsl_esai_probe(struct platform_device *pdev) { struct device_node *np = pdev->dev.of_node; @@ -969,8 +972,7 @@ static int fsl_esai_probe(struct platform_device *pdev) if (IS_ERR(regs)) return PTR_ERR(regs); - esai_priv->regmap = devm_regmap_init_mmio_clk(&pdev->dev, - "core", regs, &fsl_esai_regmap_config); + esai_priv->regmap = devm_regmap_init_mmio(&pdev->dev, regs, &fsl_esai_regmap_config); if (IS_ERR(esai_priv->regmap)) { dev_err(&pdev->dev, "failed to init regmap: %ld\n", PTR_ERR(esai_priv->regmap)); @@ -1039,11 +1041,23 @@ static int fsl_esai_probe(struct platform_device *pdev) } dev_set_drvdata(&pdev->dev, esai_priv); - spin_lock_init(&esai_priv->lock); + pm_runtime_enable(&pdev->dev); + if (!pm_runtime_enabled(&pdev->dev)) { + ret = fsl_esai_runtime_resume(&pdev->dev); + if (ret) + goto err_pm_disable; + } + + ret = pm_runtime_get_sync(&pdev->dev); + if (ret < 0) { + pm_runtime_put_noidle(&pdev->dev); + goto err_pm_get_sync; + } + ret = fsl_esai_hw_init(esai_priv); if (ret) - return ret; + goto err_pm_get_sync; esai_priv->tx_mask = 0xFFFFFFFF; esai_priv->rx_mask = 0xFFFFFFFF; @@ -1054,24 +1068,33 @@ static int fsl_esai_probe(struct platform_device *pdev) regmap_write(esai_priv->regmap, REG_ESAI_RSMA, 0); regmap_write(esai_priv->regmap, REG_ESAI_RSMB, 0); + ret = pm_runtime_put_sync(&pdev->dev); + if (ret < 0) + goto err_pm_get_sync; + ret = devm_snd_soc_register_component(&pdev->dev, &fsl_esai_component, &fsl_esai_dai, 1); if (ret) { dev_err(&pdev->dev, "failed to register DAI: %d\n", ret); - return ret; + goto err_pm_get_sync; } INIT_WORK(&esai_priv->work, fsl_esai_hw_reset); - pm_runtime_enable(&pdev->dev); - - regcache_cache_only(esai_priv->regmap, true); - ret = imx_pcm_dma_init(pdev, IMX_ESAI_DMABUF_SIZE); - if (ret) + if (ret) { dev_err(&pdev->dev, "failed to init imx pcm dma: %d\n", ret); + goto err_pm_get_sync; + } return ret; + +err_pm_get_sync: + if (!pm_runtime_status_suspended(&pdev->dev)) + fsl_esai_runtime_suspend(&pdev->dev); +err_pm_disable: + pm_runtime_disable(&pdev->dev); + return ret; } static int fsl_esai_remove(struct platform_device *pdev) @@ -1079,6 +1102,9 @@ static int fsl_esai_remove(struct platform_device *pdev) struct fsl_esai *esai_priv = platform_get_drvdata(pdev); pm_runtime_disable(&pdev->dev); + if (!pm_runtime_status_suspended(&pdev->dev)) + fsl_esai_runtime_suspend(&pdev->dev); + cancel_work_sync(&esai_priv->work); return 0; @@ -1092,7 +1118,6 @@ static const struct of_device_id fsl_esai_dt_ids[] = { }; MODULE_DEVICE_TABLE(of, fsl_esai_dt_ids); -#ifdef CONFIG_PM static int fsl_esai_runtime_resume(struct device *dev) { struct fsl_esai *esai = dev_get_drvdata(dev); @@ -1160,7 +1185,6 @@ static int fsl_esai_runtime_suspend(struct device *dev) return 0; } -#endif /* CONFIG_PM */ static const struct dev_pm_ops fsl_esai_pm_ops = { SET_RUNTIME_PM_OPS(fsl_esai_runtime_suspend, -- 2.27.0