[PATCH 07/12] remoteproc: qcom_q6v5_pas: make use of QCOM_FW_HELPER

[Dmitry Baryshkov]

Make the driver use qcom_fw_helper to autodetect the path to the
calibration data file.

Signed-off-by: Dmitry Baryshkov <dmitry.barysh...@linaro.org>
---
 drivers/remoteproc/Kconfig         | 1 +
 drivers/remoteproc/qcom_q6v5_pas.c | 9 +++++++++
 2 files changed, 10 insertions(+)

diff --git a/drivers/remoteproc/Kconfig b/drivers/remoteproc/Kconfig
index 884e1e69bbb6..7bb22fdb64e4 100644
--- a/drivers/remoteproc/Kconfig
+++ b/drivers/remoteproc/Kconfig
@@ -223,6 +223,7 @@ config QCOM_Q6V5_PAS
        depends on RPMSG_QCOM_GLINK || RPMSG_QCOM_GLINK=n
        depends on QCOM_AOSS_QMP || QCOM_AOSS_QMP=n
        select MFD_SYSCON
+       select QCOM_FW_HELPER
        select QCOM_PIL_INFO
        select QCOM_MDT_LOADER
        select QCOM_Q6V5_COMMON
diff --git a/drivers/remoteproc/qcom_q6v5_pas.c 
b/drivers/remoteproc/qcom_q6v5_pas.c
index 4694ec4f038d..893fda54b598 100644
--- a/drivers/remoteproc/qcom_q6v5_pas.c
+++ b/drivers/remoteproc/qcom_q6v5_pas.c
@@ -22,6 +22,7 @@
 #include <linux/firmware/qcom/qcom_scm.h>
 #include <linux/regulator/consumer.h>
 #include <linux/remoteproc.h>
+#include <linux/soc/qcom/fw_helper.h>
 #include <linux/soc/qcom/mdt_loader.h>
 #include <linux/soc/qcom/smem.h>
 #include <linux/soc/qcom/smem_state.h>
@@ -705,11 +706,19 @@ static int adsp_probe(struct platform_device *pdev)
                                                    &dtb_fw_name);
                if (ret < 0 && ret != -EINVAL)
                        return ret;
+
+               dtb_fw_name = devm_qcom_get_board_fw(&pdev->dev, dtb_fw_name);
+               if (!dtb_fw_name)
+                       return -ENOMEM;
        }
 
        if (desc->minidump_id)
                ops = &adsp_minidump_ops;
 
+       fw_name = qcom_get_board_fw(fw_name);
+       if (!fw_name)
+               return -ENOMEM;
+
        rproc = devm_rproc_alloc(&pdev->dev, pdev->name, ops, fw_name, 
sizeof(*adsp));
 
        if (!rproc) {

-- 
2.39.2