Hi, On Fri, Jun 13, 2025 at 01:08:07PM -0400, Demi Marie Obenour wrote: > I’m working on virtio-IOMMU interrupt remapping for Spectrum OS [1], > and am running into a problem. All of the current interrupt remapping > drivers use __init code during initialization, and I’m not sure how to > plumb the struct virtio_device * into the IOMMU initialization code. > > What is the proper way to do this, where “proper” means that it doesn’t > do something disgusting like “stuff the virtio device in a global > variable”?
I'm not familiar at all with interrupt remapping, but I suspect a major hurdle will be device probing order: the PCI subsystem probes the virtio-pci transport device relatively late during boot, and the virtio driver probes the virtio-iommu device afterwards, at which point we can call viommu_probe() and inspect the device features and config. This can be quite late in userspace if virtio and virtio-iommu get loaded as modules (which distros tend to do). The way we know to hold off initializing dependent devices before the IOMMU is ready is by reading the firmware tables. In devicetree the "msi-parent" and "msi-map" properties point to the interrupt remapping device, so by reading those Linux knows to wait for the probe of the remapping device before setting up those endpoints. The ACPI VIOT describes this topology as well, although at the moment it does not have separate graphs for MMU and interrupts, like devicetree does (could probably be added to the spec if needed, but I'm guessing the topologies may be the same for a VM). If the interrupt infrastructure supports probe deferral, then that's probably the way to go. Thanks, Jean
