Add a dts for the PMIC used e.g. with SM7635 devices. Signed-off-by: Luca Weiss <[email protected]> --- arch/arm64/boot/dts/qcom/pmiv0104.dtsi | 63 ++++++++++++++++++++++++++++++++++ 1 file changed, 63 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/pmiv0104.dtsi b/arch/arm64/boot/dts/qcom/pmiv0104.dtsi new file mode 100644 index 0000000000000000000000000000000000000000..04d929db76f409c49c47ef0147a3de568006973a --- /dev/null +++ b/arch/arm64/boot/dts/qcom/pmiv0104.dtsi @@ -0,0 +1,63 @@ +// SPDX-License-Identifier: BSD-3-Clause +/* + * Copyright (c) 2025, Luca Weiss <[email protected]> + */ + +#include <dt-bindings/interrupt-controller/irq.h> +#include <dt-bindings/spmi/spmi.h> + +/ { + thermal-zones { + pmiv0104-thermal { + polling-delay-passive = <100>; + + thermal-sensors = <&pmiv0104_temp_alarm>; + + trips { + trip0 { + temperature = <95000>; + hysteresis = <0>; + type = "passive"; + }; + + trip1 { + temperature = <115000>; + hysteresis = <0>; + type = "hot"; + }; + }; + }; + }; +}; + +&spmi_bus { + pmic@PMIV0104_SID { + compatible = "qcom,pmiv0104", "qcom,spmi-pmic"; + reg = <PMIV0104_SID SPMI_USID>; + #address-cells = <1>; + #size-cells = <0>; + + pmiv0104_temp_alarm: temp-alarm@a00 { + compatible = "qcom,spmi-temp-alarm"; + reg = <0xa00>; + interrupts = <PMIV0104_SID 0xa 0x0 IRQ_TYPE_EDGE_BOTH>; + #thermal-sensor-cells = <0>; + }; + + pmiv0104_gpios: gpio@8800 { + compatible = "qcom,pmiv0104-gpio", "qcom,spmi-gpio"; + reg = <0x8800>; + gpio-controller; + gpio-ranges = <&pmiv0104_gpios 0 0 10>; + #gpio-cells = <2>; + interrupt-controller; + #interrupt-cells = <2>; + }; + + pmiv0104_eusb2_repeater: phy@fd00 { + compatible = "qcom,pmiv0104-eusb2-repeater"; + reg = <0xfd00>; + #phy-cells = <0>; + }; + }; +}; -- 2.50.0
