linux-postmarketos-qcom-sdm845-6.16.7_p20251203010632-r0.apk
December 1, 2025 at 11:42 AM, "Konrad Dybcio" <[email protected] mailto:[email protected]?to=%22Konrad%20Dybcio%22%20%3Ckonrad.dybcio%40oss.qualcomm.com%3E > wrote: > > On 11/28/25 9:20 PM, Paul Sajna wrote: > > > > > I did more testing on this, and the led only comes on if it's brightness is > > set to approx 150/255 or lower. In that case, should I set led-max-microamp > > to 60mA? > > > FWIW your downstream kernel sets up channels 0 and 1, here you only > enabled 1. Taking a look at a picture of the phone, I only see a single > LED on the back, so perhaps you're (over)driving a single power line? > > I'm not a milion percent sure, but I would assume the current draw > *limiting* register applies to the sum of the current going through > the three channels because there's only a single instance of it. > > Konrad > I tried setting up both, but only the one that was mapped as `led-sources = <2>` seemed to have any effect. Also it would confuse userspace flashlight apps if there were two I think. So I'll push v5 with just the one that does anything.
