On Mon, Jan 12, 2026 at 06:16:42AM -0800, Jakub Kicinski wrote:
> On Mon, 12 Jan 2026 09:40:58 +0000 Andre Carvalho wrote:
> > Introduce a new netconsole selftest to validate that netconsole is able
> > to resume a deactivated target when the low level interface comes back.
> >
> > The test setups the network using netdevsim, creates a netconsole target
> > and then remove/add netdevsim in order to bring the same interfaces
> > back. Afterwards, the test validates that the target works as expected.
> >
> > Targets are created via cmdline parameters to the module to ensure that
> > we are able to resume targets that were bound by mac and interface name.
>
> The new test seems to be failing in netdev CI:
>
> TAP version 13
> 1..1
> # timeout set to 180
> # selftests: drivers/net: netcons_resume.sh
> # Running with bind mode: ifname
> not ok 1 selftests: drivers/net: netcons_resume.sh # exit=1
> --
> pw-bot: cr
I've finally been able to reproduce this locally. The issue is caused by the
fact that the test currently expects that mac addresses for netdevsim devices
are
deterministic. This is the case on my setup as systemd enforces it
(MACAddressPolicy=persistent).
I was able to disable this behaviour by setting up
/etc/systemd/network/50-netdevsim.link, with:
[Match]
Driver=netdevsim
[Link]
MACAddressPolicy=none
I'm assuming this is also the behaviour on CI hosts. I have started working on
a fix
for this test and will submit v11 once that is ready. The approach I'm taking
is saving and
restoring the mac addresses once I reload netdevsim module. Example code below
(needs more testing):
function deactivate() {
# Start by storing mac addresses so we can be restored in reactivate
SAVED_DSTMAC=$(ip netns exec "${NAMESPACE}" \
cat /sys/class/net/"$DSTIF"/address)
SAVED_SRCMAC=$(mac_get "${SRCIF}")
# Remove low level module
rmmod netdevsim
}
function reactivate() {
# Add back low level module
modprobe netdevsim
# Recreate namespace and two interfaces
set_network
# Restore MACs
ip netns exec "${NAMESPACE}" ip link set "${DSTIF}" \
address "${SAVED_DSTMAC}"
if [ "${BINDMODE}" == "mac" ]; then
ip link set dev "${SRCIF}" down
ip link set dev "${SRCIF}" address "${SAVED_SRCMAC}"
# Rename device in order to trigger target resume, as initial
# when device was recreated it didnt have correct mac address.
ip link set dev "${SRCIF}" name "${TARGET}"
fi
}
The main annoyance is that to test resuming when a device was bound by mac I
actually need
to change the name of the device after restoring the mac address (since when
the device
is registered after deactivation the mac won't match).
--
Andre Carvalho
