Hello,

Thanks for reviews. Please see my comments below.

On 4/23/2026 4:09 AM, Krzysztof Kozlowski wrote:
> On Wed, Apr 22, 2026 at 01:25:57PM -0700, Tanmay Shah wrote:
>> Add auto-boot property to notify that remote processor is setup and
>> ready to boot. Linux can attempt to boot or attach to already running
>> remote processor. "firmware-name" property is used to mention default
>> firmware to boot when linux starts the remote processor.
>>
>> Signed-off-by: Tanmay Shah <[email protected]>
>> ---
>>  .../devicetree/bindings/remoteproc/xlnx,zynqmp-r5fss.yaml | 8 ++++++++
>>  1 file changed, 8 insertions(+)
>>
>> diff --git 
>> a/Documentation/devicetree/bindings/remoteproc/xlnx,zynqmp-r5fss.yaml 
>> b/Documentation/devicetree/bindings/remoteproc/xlnx,zynqmp-r5fss.yaml
>> index ee63c03949c9..0d27260e3baa 100644
>> --- a/Documentation/devicetree/bindings/remoteproc/xlnx,zynqmp-r5fss.yaml
>> +++ b/Documentation/devicetree/bindings/remoteproc/xlnx,zynqmp-r5fss.yaml
>> @@ -135,6 +135,14 @@ patternProperties:
>>            - description: vring1
>>          additionalItems: true
>>  
>> +      auto-boot:
> 
> Last months, I have been asking AMD to follow writing-bindings doc or
> other DT guidelines way too many times.
> 
> Or you just sent us downstream... Do you see anywhere such property?
> What properties do you see? How are they named?
> 

I should have put note about this. Current auto-boot properties are
named like st,auto-boot fsl,auto-boot etc. but nothing vendor specific
there. Can we have a common auto-boot property? Similar to
firmware-name? If we agree to it then what's the correct location? New
file remoteproc.yaml is okay?

>> +        type: boolean
>> +        description: remote core is either already running or ready to boot
> 
> And why is this property of a board?
> 

Not sure what indicates it is? The property is under remoteproc child
device that is SOC level property. Remote core is on same SOC wher linux
core is running.

>> +
>> +      firmware-name:
>> +        maxItems: 1
>> +        description: default firmware to load
> 
> Can you load non-default firmware later? IOW, why adding description
> here, what is special?
> 

The rootfs contains other firmware demos, and it is possible to stop the
default firmware, load other fw elf and re-run the remote core.
I don't have strong preference on the description part, I will remove it
if redundant.

> Best regards,
> Krzysztof
> 


Reply via email to