On 5/8/26 10:23 AM, Shuah Khan wrote:
> On 5/8/26 10:38, Adrien Reynard wrote:
>
> Missing commit log
>
>> Signed-off-by: Adrien Reynard <[email protected]>
>> ---
>> Documentation/dev-tools/kasan.rst | 2 +-
>> Documentation/networking/switchdev.rst | 2 +-
>> Documentation/virt/uml/user_mode_linux_howto_v2.rst | 2 +-
>> 3 files changed, 3 insertions(+), 3 deletions(-)
>>
>> diff --git a/Documentation/dev-tools/kasan.rst
>> b/Documentation/dev-tools/kasan.rst
>> index 4968b2aa60c8..3a8bd40ad905 100644
>> --- a/Documentation/dev-tools/kasan.rst
>> +++ b/Documentation/dev-tools/kasan.rst
>> @@ -392,7 +392,7 @@ reserved to tag freed memory regions.
>> If the hardware does not support MTE (pre ARMv8.5), Hardware Tag-Based
>> KASAN
>> will not be enabled. In this case, all KASAN boot parameters are ignored.
>> -Note that enabling CONFIG_KASAN_HW_TAGS always results in in-kernel TBI
>> being
>> +Note that enabling CONFIG_KASAN_HW_TAGS always results in-kernel TBI being
>
> This is correct the way it is - no need to change this. "results in in-kernel"
ack.
>> enabled. Even when ``kasan.mode=off`` is provided or when the hardware
>> does not
>> support MTE (but supports TBI).
>> diff --git a/Documentation/networking/switchdev.rst
>> b/Documentation/networking/switchdev.rst
>> index 2966b7122f05..948bce44ca9b 100644
>> --- a/Documentation/networking/switchdev.rst
>> +++ b/Documentation/networking/switchdev.rst
>> @@ -162,7 +162,7 @@ The switchdev driver can know a particular port's
>> position in the topology by
>> monitoring NETDEV_CHANGEUPPER notifications. For example, a port moved
>> into a
>> bond will see its upper master change. If that bond is moved into a
>> bridge,
>> the bond's upper master will change. And so on. The driver will track
>> such
>> -movements to know what position a port is in in the overall topology by
>> +movements to know what position a port is in the overall topology by
>
> This looks fine.
Change not needed.
>> registering for netdevice events and acting on NETDEV_CHANGEUPPER.
>> L2 Forwarding Offload
>> diff --git a/Documentation/virt/uml/user_mode_linux_howto_v2.rst
>> b/Documentation/virt/uml/user_mode_linux_howto_v2.rst
>> index c37e8e594d12..7b08738c30aa 100644
>> --- a/Documentation/virt/uml/user_mode_linux_howto_v2.rst
>> +++ b/Documentation/virt/uml/user_mode_linux_howto_v2.rst
>> @@ -1092,7 +1092,7 @@ be formatted as plain text.
>> Developing always goes hand in hand with debugging. First of all,
>> you can always run UML under gdb and there will be a whole section
>> -later on on how to do that. That, however, is not the only way to
>> +later on how to do that. That, however, is not the only way to
>
> This change is not needed. If at all add a comma after "later" to make
> a distinction between the use two back to back "on"s
>
> "later on,"
We disagree. :)
This change LGTM.
--
~Randy
