On Thu, Oct 25, 2012 at 11:29 AM, Ulf Hansson <ulf.hans...@linaro.org> wrote:
> Depending on clock type, a clk_disable is actually not going to "gate" > the clock, that might happen only in unprepare. This depends on if the > clock is a fast or slow clock. Hm thats interesting. Now I need to drill down into this. So looking at it in this case: clk_disable() from the GPIO block of the pin controller will hit "gpio.0", "gpio.1" etc in drivers/clk/ux500/u8500_clk.c. These are PRCC (Programmable Clock Controller) clocks registered using clk_reg_prcc_pclk() from clk-prcc.c. pclk:s are using the clk_prcc_pclk_ops and these point to clk_prcc_pclk_enable()/clk_prcc_pclk_disable() for enable/disable respectively. These will just write a PRCC register. And prepare() and unprepare() are not implemented for this clock. So far we can conclude that clk_enable()/disable() will indeed achieve the desired effect of gating the clock to the GPIO block per se, so we are saving some power for sure. However the prepare()/unprepare() calls will of course also accumulate upwards and in e.g. the example of "gpio.0" and "gpio.1" the parent is "per1clk" which is the clock for the entire peripheral group. (At this point I can stick in a reminder of the idea to restructure the device tree in peripheral groups, because that exercise will certainly pay off the day we try to encode clocks in the device tree, I think the point can be clearly seen as we proceed...) This "per1clk" is registered using clk_req_prcmu_gate() from clk-prcmu.c. Looking at that clock type we find it's a plain software dummy for the clk_enable()/clk_disable() path. The real action is happening in the prepare()/unprepare() path. So to be able to shut down the entire peripheral cluster, indeed both functions need to be called. So in accordance with this we can see that the patch should be applied, in some form. However it is not removing the initial clk_prepare() so the entire patch will be pointless, the prepare count will currently always be > 0. I'll mangle Lee's patch a bit, hold on.. Yours, Linus Walleij -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/