Further note - kernels built with K6-2 support seem to be just fine. But
all athlon/K7 kernels die horribly, with greatly varying death messages.
Most commonly I get bogus pointer/dereference errors and eventually init
gets killed, other times it just locks up, sometimes I get things like
'cannot exec syslogd: Out of memory'. It looks like the memory registers
are horked up somehow.
I could try to copy some of this out by hand if anyone thought it
worthwhile. Either way, I think IWill has some work to do yet on their
system bios.
-dennis T
On Wed, 21 Mar 2001 [EMAIL PROTECTED] wrote:
> On 20 Mar, SodaPop wrote:
>
> > I have an IWill KK-266R motherboard with an athlon-c 1200
> > processor in it, and for the life of me I can't get more than
> > 10 MB/sec through the on-board ide controller. Yes, all the
> > appropriate support is turned on in the kernel to enable dma
> > and specific chipset support, and yes, I think I have all
> > relevant patches and a reasonable kernel.
>
> Yes, actually I'm seeing the same on a KT133 board from Elitegroup.
> Although here I get a bit more: 15 MB/s
>
> > I noted a number of other interesting things; one, that -X33,
> > -X34, and -X64 through -X69 all have the same 10 MB/sec transfer
> > rate, and two, that the 10 MB/sec transfer rate can be linearly
> > increased to 12 MB/sec by raising the system bus from 100 mhz to
> > 120 mhz (all components are safely rated at 133, no overclocking
> > involved.)
>
> Duh, before making such a claim you should consider the fact that
> this is overclocking your PCI/AGP bus and I have yet to see any
> graphic cards/IDE controllers/other devices which are rated for
> 37MHz PCI bus speed.
>
> --
>
> Servus,
> Daniel
>
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
