Hi.
I have VIA686a too and a UDMA100 hard disk.
This is my cat /proc/ide/via:
----------VIA BusMastering IDE Configuration----------------
Driver Version: 3.23
South Bridge: VIA vt82c686a
Revision: ISA 0x22 IDE 0x10
Highest DMA rate: UDMA66
BM-DMA base: 0xb800
PCI clock: 33MHz
Master Read Cycle IRDY: 0ws
Master Write Cycle IRDY: 0ws
BM IDE Status Register Read Retry: yes
Max DRDY Pulse Width: No limit
-----------------------Primary IDE-------Secondary IDE------
Read DMA FIFO flush: yes yes
End Sector FIFO flush: no no
Prefetch Buffer: no no
Post Write Buffer: no no
Enabled: yes yes
Simplex only: no no
Cable Type: 40w 40w
-------------------drive0----drive1----drive2----drive3-----
Transfer Mode: DMA UDMA PIO PIO
Address Setup: 30ns 30ns 120ns 120ns
Cmd Active: 90ns 90ns 480ns 480ns
Cmd Recovery: 30ns 30ns 480ns 480ns
Data Active: 90ns 90ns 330ns 330ns
Data Recovery: 30ns 30ns 270ns 270ns
Cycle Time: 120ns 60ns 600ns 600ns
Transfer Rate: 16.5MB/s 33.0MB/s 3.3MB/s 3.3MB/s
As you can see, l use UDMA66 instead UDMA100. I don't know why. Maybe VIA
vt82c686a doesn't support it? I have answering in this list a days ago about this
problem. but none seems to have a question. Like you, my system goes down when I try
to compile something (I have a 394 Mb of RAM and a 1 Ghz processor).
Although, my hdparm output is this:
/dev/hde2:
Timing buffer-cache reads: 128 MB in 0.79 seconds =162.03 MB/sec
Timing buffered disk reads: 64 MB in 2.44 seconds = 26.23 MB/sec
and sometime looks better.
I don't know is this is a problem with the VIA kernel driver or not. But the
system doesn't seem to work fine since 2.4.2 or 2.4.1 kernel. I hope (plz!) this
problem will be fixed in future.
Luck.
PS: in cat /proc/ide/via I see "Cable Type: 40w
40w"... Is it right? I have a 80w cable, not 40.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
