On 04/16/2013 07:58 PM, Boszormenyi Zoltan wrote:
Hi,
The SATA interface can be switched between AHCI and legacy modes as usual:
00:1f.2 SATA controller: Intel Corporation NM10/ICH7 Family SATA
Controller [AHCI mode] (rev 02)
The device attached to the SATA controller is always a CF card via a
SiI3811 Serial ATA to Parallel ATA Device Bridge based converter board.
Can you please attach a normal sata disk and try again with the
controller set to AHCI mode? I suspect it may be the SiI3811 bridge that
caused this command.
Thanks,
Aaron
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/