The EHCI host controller driver can be built standalone now, without enabling any of the available bus glue drivers, so there is not really a reason to error out here:
drivers/usb/host/ehci-hcd.c:1303:2: error: #error "missing bus glue for ehci-hcd" #error "missing bus glue for ehci-hcd" The alternative would be to change the Kconfig code to build the ehci-hcd module only if any of the symbols below are in fact enabled. Cc: Alan Stern <[email protected]> Cc: Greg Kroah-Hartman <[email protected]> Signed-off-by: Arnd Bergmann <[email protected]> --- drivers/usb/host/ehci-hcd.c | 17 ----------------- 1 file changed, 17 deletions(-) diff --git a/drivers/usb/host/ehci-hcd.c b/drivers/usb/host/ehci-hcd.c index 312fc10..246e124 100644 --- a/drivers/usb/host/ehci-hcd.c +++ b/drivers/usb/host/ehci-hcd.c @@ -1286,23 +1286,6 @@ MODULE_LICENSE ("GPL"); #define PLATFORM_DRIVER ehci_hcd_sead3_driver #endif -#if !IS_ENABLED(CONFIG_USB_EHCI_PCI) && \ - !IS_ENABLED(CONFIG_USB_EHCI_HCD_PLATFORM) && \ - !IS_ENABLED(CONFIG_USB_CHIPIDEA_HOST) && \ - !IS_ENABLED(CONFIG_USB_EHCI_MXC) && \ - !IS_ENABLED(CONFIG_USB_EHCI_HCD_OMAP) && \ - !IS_ENABLED(CONFIG_USB_EHCI_HCD_ORION) && \ - !IS_ENABLED(CONFIG_USB_EHCI_HCD_SPEAR) && \ - !IS_ENABLED(CONFIG_USB_EHCI_S5P) && \ - !IS_ENABLED(CONFIG_USB_EHCI_HCD_AT91) && \ - !IS_ENABLED(CONFIG_USB_EHCI_MSM) && \ - !defined(PLATFORM_DRIVER) && \ - !defined(PS3_SYSTEM_BUS_DRIVER) && \ - !defined(OF_PLATFORM_DRIVER) && \ - !defined(XILINX_OF_PLATFORM_DRIVER) -#error "missing bus glue for ehci-hcd" -#endif - static int __init ehci_hcd_init(void) { int retval = 0; -- 1.8.1.2 -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
