This patch proposes to remove kernel configuration parameters defined in drivers/mtd/devices/Kconfig, but used nowhere in the makefiles and source code (except in comments).
Signed-off-by: Michael Opdenacker <[email protected]> --- drivers/mtd/devices/Kconfig | 55 ------------------------------------------- drivers/mtd/nand/diskonchip.c | 4 ++-- 2 files changed, 2 insertions(+), 57 deletions(-) diff --git a/drivers/mtd/devices/Kconfig b/drivers/mtd/devices/Kconfig index 2a4d55e..74ab4b7 100644 --- a/drivers/mtd/devices/Kconfig +++ b/drivers/mtd/devices/Kconfig @@ -224,59 +224,4 @@ config BCH_CONST_T default 4 endif -config MTD_DOCPROBE - tristate - select MTD_DOCECC - -config MTD_DOCECC - tristate - -config MTD_DOCPROBE_ADVANCED - bool "Advanced detection options for DiskOnChip" - depends on MTD_DOCPROBE - help - This option allows you to specify nonstandard address at which to - probe for a DiskOnChip, or to change the detection options. You - are unlikely to need any of this unless you are using LinuxBIOS. - Say 'N'. - -config MTD_DOCPROBE_ADDRESS - hex "Physical address of DiskOnChip" if MTD_DOCPROBE_ADVANCED - depends on MTD_DOCPROBE - default "0x0" - ---help--- - By default, the probe for DiskOnChip devices will look for a - DiskOnChip at every multiple of 0x2000 between 0xC8000 and 0xEE000. - This option allows you to specify a single address at which to probe - for the device, which is useful if you have other devices in that - range which get upset when they are probed. - - (Note that on PowerPC, the normal probe will only check at - 0xE4000000.) - - Normally, you should leave this set to zero, to allow the probe at - the normal addresses. - -config MTD_DOCPROBE_HIGH - bool "Probe high addresses" - depends on MTD_DOCPROBE_ADVANCED - help - By default, the probe for DiskOnChip devices will look for a - DiskOnChip at every multiple of 0x2000 between 0xC8000 and 0xEE000. - This option changes to make it probe between 0xFFFC8000 and - 0xFFFEE000. Unless you are using LinuxBIOS, this is unlikely to be - useful to you. Say 'N'. - -config MTD_DOCPROBE_55AA - bool "Probe for 0x55 0xAA BIOS Extension Signature" - depends on MTD_DOCPROBE_ADVANCED - help - Check for the 0x55 0xAA signature of a DiskOnChip, and do not - continue with probing if it is absent. The signature will always be - present for a DiskOnChip 2000 or a normal DiskOnChip Millennium. - Only if you have overwritten the first block of a DiskOnChip - Millennium will it be absent. Enable this option if you are using - LinuxBIOS or if you need to recover a DiskOnChip Millennium on which - you have managed to wipe the first block. - endmenu diff --git a/drivers/mtd/nand/diskonchip.c b/drivers/mtd/nand/diskonchip.c index 81fa578..eaa3c29 100644 --- a/drivers/mtd/nand/diskonchip.c +++ b/drivers/mtd/nand/diskonchip.c @@ -46,13 +46,13 @@ static unsigned long __initdata doc_locations[] = { 0xfffd8000, 0xfffda000, 0xfffdc000, 0xfffde000, 0xfffe0000, 0xfffe2000, 0xfffe4000, 0xfffe6000, 0xfffe8000, 0xfffea000, 0xfffec000, 0xfffee000, -#else /* CONFIG_MTD_DOCPROBE_HIGH */ +#else 0xc8000, 0xca000, 0xcc000, 0xce000, 0xd0000, 0xd2000, 0xd4000, 0xd6000, 0xd8000, 0xda000, 0xdc000, 0xde000, 0xe0000, 0xe2000, 0xe4000, 0xe6000, 0xe8000, 0xea000, 0xec000, 0xee000, -#endif /* CONFIG_MTD_DOCPROBE_HIGH */ +#endif #endif 0xffffffff }; -- 1.8.1.2 -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
