Hello to all. I have the following setup. tyan s1590s motherboard, 64mb ram, two ide ports on board, amdk63d processor. I am running debian linux using kernel 2.2.19. I have a Ricoh MP7120 cdrw drive. This is an atapi drive. Because of this I need to use the ide-scsi driver along with the sg driver. I have no trouble at all writing audio or data cds using cdrecord. The problem comes when I need to play an audio cd. If I have just put the cd in the drive, any audio cd player works fine. However after a stop command with either cdcd or cdtool, I must issue two cdcd play commands in a row, or two cdplay commands in the case of cdtool in order to get the cd to begin playing again. The cdrw drive is on the secondary port and it is a master. I have the following append command in lilo.conf append="hdc=ide-scsi" If I remove this command, and make /dev/cdrom point to /dev/hdc, the problem disappears altogether. I've looked in every log file I can find on the system and cannot find any error messages anywhere. The audio cd players just don't do anything at all on the first play command after a stop command. I've read the ide documentation, and there is very little said about ide-scsi. Does anyone have any idea as to what on earth is happening here? Thanks for any help. Sincerely, -- Rick Hayner [EMAIL PROTECTED] Member spebsqsa, Baritone Kalamazoo Mall City Chorus. Amateur radio station wa8jqv - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/