TI Cardbus bridge has unsupported PM cap regs version

[Meelis Roos]

The system is working fine, it just gives warnings about unsupported PM 
cap regs version (1). This is an excerpt from dmesg:

PCI: 0000:00:11.0 has unsupported PM cap regs version (1)
PCI: Enabling device 0000:00:11.0 (0000 -> 0002)
ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 11
PCI: setting IRQ 11 as level-triggered
ACPI: PCI interrupt 0000:00:11.0[A] -> GSI 11 (level, low) -> IRQ 11
Yenta: CardBus bridge found at 0000:00:11.0 [1179:0001]
PCI: 0000:00:11.0 has unsupported PM cap regs version (1)
Yenta: ISA IRQ mask 0x04b8, PCI irq 11
Socket status: 30000007
PCI: 0000:00:11.1 has unsupported PM cap regs version (1)
PCI: Enabling device 0000:00:11.1 (0000 -> 0002)
ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 11
ACPI: PCI interrupt 0000:00:11.1[B] -> GSI 11 (level, low) -> IRQ 11
Yenta: CardBus bridge found at 0000:00:11.1 [1179:0001]
PCI: 0000:00:11.1 has unsupported PM cap regs version (1)
Yenta: ISA IRQ mask 0x04b8, PCI irq 11
Socket status: 30000020
0000:00:11 is TI cardbus bridge with 2 ports:
0000:00:11.0 CardBus bridge: Toshiba America Info Systems ToPIC95 PCI to 
Cardbus Bridge with ZV Support (rev 32)
        Subsystem: Toshiba America Info Systems: Unknown device 0001
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- 
Stepping- SERR- FastB2B-
        Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=slow >TAbort- <TAbort- 
<MAbort- >SERR- <PERR-
        Latency: 168
        Interrupt: pin A routed to IRQ 11
        Region 0: Memory at 10001000 (32-bit, non-prefetchable) [size=4K]
        Bus: primary=00, secondary=02, subordinate=05, sec-latency=0
        Memory window 0: 10400000-107ff000 (prefetchable)
        Memory window 1: 10800000-10bff000
        I/O window 0: 00004000-000040ff
        I/O window 1: 00004400-000044ff
        BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset- 16bInt+ PostWrite+
        16-bit legacy interface ports at 0001
0000:00:11.1 CardBus bridge: Toshiba America Info Systems ToPIC95 PCI to 
Cardbus Bridge with ZV Support (rev 32)
        Subsystem: Toshiba America Info Systems: Unknown device 0001
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- 
Stepping- SERR- FastB2B-
        Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=slow >TAbort- <TAbort- 
<MAbort- >SERR- <PERR-
        Latency: 168
        Interrupt: pin B routed to IRQ 11
        Region 0: Memory at 10002000 (32-bit, non-prefetchable) [size=4K]
        Bus: primary=00, secondary=06, subordinate=09, sec-latency=0
        Memory window 0: 10c00000-10fff000 (prefetchable)
        Memory window 1: 11000000-113ff000
        I/O window 0: 00004800-000048ff
        I/O window 1: 00004c00-00004cff
        BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset- 16bInt- PostWrite+
        16-bit legacy interface ports at 0001
One of the ports has a realtek 8139c nic plugged in, the other is empty, 
but this probably doesn't matter.

--
Meelis Roos ([EMAIL PROTECTED])
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/