On 01/27/2014 06:02 PM, Russell King - ARM Linux wrote: > On Mon, Jan 27, 2014 at 04:13:56PM +0100, Guennadi Liakhovetski wrote: >> I'm working on an MMC driver with a DMA capability. All has been working >> well, until at some point I've got a bus error, when the mmc driver had >> been handed in a buffer at 0x3000 physical RAM address. The reason is, >> that on Zynq arch bus masters cannot access RAM below 0x80000. Therefore >> my question: how shall I configure this in software? > > You're going to run into all sorts of problems here. Normally, the > DMA-able memory is limited to the first N bytes of memory, not "you must > avoid the first N bytes of memory". > > Linux has it hard-coded into the memory subsystems that the DMA zone > is from the start of memory to N, the normal zone is from N to H, and > high memory is from H upwards - and allocations for high can fall back > to normal, which can fall back to DMA but not the other way around. > > Short of permanently reserving the first 0x80000 bytes of memory, I'm > not sure that there's much which can be done. You may wish to talk to > the MM gurus to see whether there's a modern alternative.
We use memblock_reserve for allocation of this space in .reserse phase.
Look at git.xilinx.com - linux repo arch/arm/mach-zynq/common.c
/**
* zynq_memory_init() - Initialize special memory
*
* We need to stop things allocating the low memory as DMA can't work in
* the 1st 512K of memory. Using reserve vs remove is not totally clear yet.
*/
static void __init zynq_memory_init(void)
{
/*
* Reserve the 0-0x4000 addresses (before page tables and kernel)
* which can't be used for DMA
*/
if (!__pa(PAGE_OFFSET))
memblock_reserve(0, 0x4000);
}
DT_MACHINE_START(XILINX_EP107, "Xilinx Zynq Platform")
...
.reserve = zynq_memory_init,
...
MACHINE_END
I have checked why we are reserving just 0 - 0x4000 when kernel starts from
0x8000
and maybe Russell can help me with this better.
I got answer that using memblock_reserve was recommended in past for that.
Why 0x4000? IRC Linux for ARM is using space for any purpose.
Russell knows this much better than I.
Thanks,
Michal
--
Michal Simek, Ing. (M.Eng), OpenPGP -> KeyID: FE3D1F91
w: www.monstr.eu p: +42-0-721842854
Maintainer of Linux kernel - Microblaze cpu - http://www.monstr.eu/fdt/
Maintainer of Linux kernel - Xilinx Zynq ARM architecture
Microblaze U-BOOT custodian and responsible for u-boot arm zynq platform
signature.asc
Description: OpenPGP digital signature
