2014-02-10 16:03 GMT+01:00 Jean-Jacques Hiblot <jjhib...@traphandler.com>:
> The initial value of the gpio is passed to gpiod_direction_output. Currently
> this value is the raw value of the GPIO line, but it should be the logical
> value.
>
> Signed-off-by: Jean-Jacques Hiblot <jjhib...@traphandler.com>
> ---
> drivers/gpio/gpiolib.c | 3 +++
> 1 file changed, 3 insertions(+)
>
> diff --git a/drivers/gpio/gpiolib.c b/drivers/gpio/gpiolib.c
> index 4e10b10..111a1f1 100644
> --- a/drivers/gpio/gpiolib.c
> +++ b/drivers/gpio/gpiolib.c
> @@ -1751,6 +1751,9 @@ int gpiod_direction_output(struct gpio_desc *desc, int
> value)
> return -EINVAL;
> }
>
> + if (test_bit(FLAG_ACTIVE_LOW, &desc->flags))
> + value = !value;
> +
> /* GPIOs used for IRQs shall not be set as output */
> if (test_bit(FLAG_USED_AS_IRQ, &desc->flags)) {
> gpiod_err(desc,
> --
> 1.8.5.3
>
Tested-by: Richard Genoud <richard.gen...@gmail.com>
I was just missing that for my gpio modem lines !
Thanks !
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
