On Wed, Jun 11, 2014 at 11:57:02PM +0800, Chew Chiau Ee wrote: > It was observed that after module removal followed by insertion, > the SW mode chipselect is not properly set. Thus causing transfer > failure due to incorrect CS toggling.
> - value &= ~SPI_CS_CONTROL_SW_MODE;
> + orig = value &= ~SPI_CS_CONTROL_SW_MODE;
> writel(value, drv_data->ioaddr + offset + SPI_CS_CONTROL);
> value = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
> if (value != orig) {
This is a *really* non-obvious fix, I'd have expected the original value
to be re-read from the hardware here rather than just tweaked, or at
least some comment explaining what's going on. Possibly also saving to
a differently named temporary variable would do it but whatever I had to
go look at the context to figure out what was happening and even there I
was unclear.
signature.asc
Description: Digital signature
