Add device tree binding for Qualcomm AHCI SATA controller and specifically
the sata controller on the IPQ806x family of SoCs.
Signed-off-by: Kumar Gala <ga...@codeaurora.org>
---
.../devicetree/bindings/ata/qcom-sata.txt | 40 ++++++++++++++++++++++
1 file changed, 40 insertions(+)
create mode 100644 Documentation/devicetree/bindings/ata/qcom-sata.txt
diff --git a/Documentation/devicetree/bindings/ata/qcom-sata.txt
b/Documentation/devicetree/bindings/ata/qcom-sata.txt
new file mode 100644
index 0000000..5e74e41
--- /dev/null
+++ b/Documentation/devicetree/bindings/ata/qcom-sata.txt
@@ -0,0 +1,40 @@
+* Qualcomm AHCI SATA Controller
+
+SATA nodes are defined to describe on-chip Serial ATA controllers.
+Each SATA controller should have its own node.
+
+Required properties:
+- compatible : compatible list, contains "qcom,msm-ahci"
+- interrupts : <interrupt mapping for SATA IRQ>
+- reg : <registers mapping>
+- phys : Must contain exactly one entry as specified
+ in phy-bindings.txt
+- phy-names : Must be "sata-phy"
+
+Required properties for "qcom,ipq806x-ahci" compatible:
+- clocks : Must contain an entry for each entry in clock-names.
+- clock-names : Shall be:
+ "slave_iface" - Fabric port AHB clock for SATA
+ "iface" - AHB clock
+ "core" - core clock
+ "rxoob" - RX out-of-band clock
+ "pmalive" - Power Module Alive clock
+
+Example:
+ sata@29000000 {
+ compatible = "qcom,ipq806x-ahci", "qcom,msm-ahci";
+ reg = <0x29000000 0x180>;
+
+ interrupts = <0 209 0x0>;
+
+ clocks = <&gcc SFAB_SATA_S_H_CLK>,
+ <&gcc SATA_H_CLK>,
+ <&gcc SATA_A_CLK>,
+ <&gcc SATA_RXOOB_CLK>,
+ <&gcc SATA_PMALIVE_CLK>;
+ clock-names = "slave_iface", "iface", "core",
+ "rxoob", "pmalive";
+
+ phys = <&sata_phy>;
+ phy-names = "sata-phy";
+ };
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
hosted by The Linux Foundation
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
