Hi, I have a board, with a Freescale i.MX6 chip and a ECP3-35 FPGA on SPI. I tried to load the firmware using the lattice-ecp3-config driver, but it fails with this error :
lattice-ecp3 spi32766.3: FPGA bitstream configuration driver registered lattice-ecp3 spi32766.3: Error: No supported FPGA detected (JEDEC_ID=808004c2)! In the driver, the id is : #define ID_ECP3_35 0xc2048080 Obviously, there is a big/little endian issue... Do I need to instruct the device-tree in a specific way in order to get the bus in the correct order ? Or is this a known issue maybe ? Thanks, JM -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
