This v5 patch set is updated based on cyapa v4 patches, it has below updates: 1) Uses get_device()/put_device() instead of kobject_get()/kobject_put(); 2) Fix memories freed before debugfs entries issue; 3) Make cyapa_debugs_root valid in driver module level in module_init()/moudle_exit() ; 4) Fix i2c_transfer() may return partial transfer issues. 5) Add cyapa->removed flag to avoid detecting thread may still running when driver module is removed. 6) Fix the meanings of some comments and return error code not clear issue.
This patch set is aimed to re-architecture the cyapa driver to support old gen3 trackpad device and new gen5 trackpad device in one cyapa driver for easily productions support based on customers' requirements, and add sysfs functions and interfaces supported that required by users and customers. Because the earlier gen3 and the latest gen5 trackpad devies using two different chipsets, and have different protocol and interfaces. If supported these two trackpad devices in two different drivers, then it will be difficult to manage productions and later firmware updates. it will cause customer don't know which one to use and update because these two trackpad devices have been used and integrated in same one productions at a time, so must to support these two trackpad devices in same on driver. The new architecture is made of: cyapa.c - the core of the architecture, supply interfaces and functions to system and read trackpad devices. cyapa_gen3.c - functions support for gen3 trackpad devices, cyapa_gen5.c - functions support for gen5 trackpad devices. Beside this introduction patch, it has 14 patches listed as below. For these patches each one is patched based on previous one. patch 1/14: re-architecture cyapa driver with core functions, and applying the device detecting function in async thread to speed up system boot time. patch 2/14: add cyapa driver power management interfaces support. patch 3/14: add cyapa driver runtime power management interfaces support. patch 4/14: add cyapa key function interfaces in sysfs system. Including read firmware version, get production ID, read baseline, re-calibrate trackpad baselines and do trackpad firmware update. patch 5/14: add read firmware image and read raw trackpad device' sensors' raw data interface in debugfs system. patch 6/14: add gen3 trackpad device basic functions support. patch 7/14: add gen3 trackpad device firmware update function support. patch 8/14: add gen3 trackpad device report baseline and do force re-calibrate functions support. patch 9/14: add gen3 trackpad device read firmware image function support. patch 10/14: add gen5 trackpad device basic functions support. patch 11/14: add gen5 trackpad device firmware update function support. patch 12/14: add gen5 trackpad device report baseline and do force re-calibrate functions support. patch 13/14: add gen5 trackpad device read firmware image and report sensors' raw data values functions support. patch 14/14: add function to monitor LID close event to off trackpad device. -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/