On Wednesday 03 September 2014 09:07 PM, Gabriel FERNANDEZ wrote:
> SSC is the technique of modulating the operating frequency of a signal
> slightly to spread its radiated emissions over a range of frequencies.
> This reduction in the maximum emission for a given frequency helps meet
> radiated emission requirements.
> These settings are applicable for PCIE with Internal clock.
>
> Signed-off-by: Harsh Gupta <harsh.gu...@st.com>
> Signed-off-by: Gabriel Fernandez <gabriel.fernan...@linaro.orgm>
> ---
> drivers/phy/phy-miphy28lp.c | 32 ++++++++++++++++++++++++++++++++
> 1 file changed, 32 insertions(+)
>
> diff --git a/drivers/phy/phy-miphy28lp.c b/drivers/phy/phy-miphy28lp.c
> index b36e737..976fdda 100644
> --- a/drivers/phy/phy-miphy28lp.c
> +++ b/drivers/phy/phy-miphy28lp.c
> @@ -679,6 +679,36 @@ static int miphy28lp_init_sata(struct miphy28lp_phy
> *miphy_phy)
> return miphy_is_ready(miphy_phy);
> }
>
> +static void miphy_pcie_tune_ssc(struct miphy28lp_phy *miphy_phy)
> +{
> + u8 val;
> +
> + /* Compensate Tx impedance to avoid out of range values */
> + if (miphy_phy->ssc) {
> + /*
> + * Enable the SSC on PLL for all banks
> + * SSC Modulation @ 31 KHz and 4000 ppm modulation amp
> + */
> + val = readb_relaxed(miphy_phy->base + 0x0c);
> + val |= 0x04;
> + writeb_relaxed(val, miphy_phy->base + 0x0c);
> + val = readb_relaxed(miphy_phy->base + 0x0a);
> + val |= 0x10;
> + writeb_relaxed(val, miphy_phy->base + 0x0a);
macros for these registers and values is needed. Or else it's difficult to
review.
> +
> + for (val = 0; val < 2; val++) {
> + writeb_relaxed(val, miphy_phy->base + 0x0f);
> + writeb_relaxed(0x69, miphy_phy->base + 0xe5);
Do these registers have to be written for every iteration?
Thanks
Kishon
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
