With properly using libphy PHYs now, remove the in-driver PHY
mangling.
Signed-off-by: Sebastian Hesselbarth <sebastian.hesselba...@gmail.com>
---
Cc: "David S. Miller" <da...@davemloft.net>
Cc: "Antoine Ténart" <antoine.ten...@free-electrons.com>
Cc: Florian Fainelli <f.faine...@gmail.com>
Cc: Eric Miao <eric.y.m...@gmail.com>
Cc: Haojian Zhuang <haojian.zhu...@gmail.com>
Cc: linux-arm-ker...@lists.infradead.org
Cc: net...@vger.kernel.org
Cc: linux-kernel@vger.kernel.org
---
drivers/net/ethernet/marvell/pxa168_eth.c | 126 ------------------------------
1 file changed, 126 deletions(-)
diff --git a/drivers/net/ethernet/marvell/pxa168_eth.c
b/drivers/net/ethernet/marvell/pxa168_eth.c
index a406a91812c5..4e77c5142544 100644
--- a/drivers/net/ethernet/marvell/pxa168_eth.c
+++ b/drivers/net/ethernet/marvell/pxa168_eth.c
@@ -177,7 +177,6 @@
#define LINK_UP (1 << 3)
/* Bit definitions for work to be done */
-#define WORK_LINK (1 << 0)
#define WORK_TX_DONE (1 << 1)
/*
@@ -284,7 +283,6 @@ static void eth_port_reset(struct net_device *dev);
static void eth_port_start(struct net_device *dev);
static int pxa168_eth_open(struct net_device *dev);
static int pxa168_eth_stop(struct net_device *dev);
-static int ethernet_phy_setup(struct net_device *dev);
static inline u32 rdl(struct pxa168_eth_private *pep, int offset)
{
@@ -316,26 +314,6 @@ static void abort_dma(struct pxa168_eth_private *pep)
netdev_err(pep->dev, "%s : DMA Stuck\n", __func__);
}
-static int ethernet_phy_get(struct pxa168_eth_private *pep)
-{
- unsigned int reg_data;
-
- reg_data = rdl(pep, PHY_ADDRESS);
-
- return (reg_data >> (5 * pep->port_num)) & 0x1f;
-}
-
-static void ethernet_phy_set_addr(struct pxa168_eth_private *pep, int phy_addr)
-{
- u32 reg_data;
- int addr_shift = 5 * pep->port_num;
-
- reg_data = rdl(pep, PHY_ADDRESS);
- reg_data &= ~(0x1f << addr_shift);
- reg_data |= (phy_addr & 0x1f) << addr_shift;
- wrl(pep, PHY_ADDRESS, reg_data);
-}
-
static void rxq_refill(struct net_device *dev)
{
struct pxa168_eth_private *pep = netdev_priv(dev);
@@ -890,43 +868,9 @@ static int pxa168_eth_collect_events(struct
pxa168_eth_private *pep,
}
if (icr & ICR_RXBUF)
ret = 1;
- if (icr & ICR_MII_CH) {
- pep->work_todo |= WORK_LINK;
- ret = 1;
- }
return ret;
}
-static void handle_link_event(struct pxa168_eth_private *pep)
-{
- struct net_device *dev = pep->dev;
- u32 port_status;
- int speed;
- int duplex;
- int fc;
-
- port_status = rdl(pep, PORT_STATUS);
- if (!(port_status & LINK_UP)) {
- if (netif_carrier_ok(dev)) {
- netdev_info(dev, "link down\n");
- netif_carrier_off(dev);
- txq_reclaim(dev, 1);
- }
- return;
- }
- if (port_status & PORT_SPEED_100)
- speed = 100;
- else
- speed = 10;
-
- duplex = (port_status & FULL_DUPLEX) ? 1 : 0;
- fc = (port_status & FLOW_CONTROL_DISABLED) ? 0 : 1;
- netdev_info(dev, "link up, %d Mb/s, %s duplex, flow control %sabled\n",
- speed, duplex ? "full" : "half", fc ? "en" : "dis");
- if (!netif_carrier_ok(dev))
- netif_carrier_on(dev);
-}
-
static irqreturn_t pxa168_eth_int_handler(int irq, void *dev_id)
{
struct net_device *dev = (struct net_device *)dev_id;
@@ -1301,10 +1245,6 @@ static int pxa168_rx_poll(struct napi_struct *napi, int
budget)
struct net_device *dev = pep->dev;
int work_done = 0;
- if (unlikely(pep->work_todo & WORK_LINK)) {
- pep->work_todo &= ~(WORK_LINK);
- handle_link_event(pep);
- }
/*
* We call txq_reclaim every time since in NAPI interupts are disabled
* and due to this we miss the TX_DONE interrupt,which is not updated in
@@ -1427,72 +1367,6 @@ static int pxa168_eth_do_ioctl(struct net_device *dev,
struct ifreq *ifr,
return -EOPNOTSUPP;
}
-static struct phy_device *phy_scan(struct pxa168_eth_private *pep, int
phy_addr)
-{
- struct mii_bus *bus = pep->smi_bus;
- struct phy_device *phydev;
- int start;
- int num;
- int i;
-
- if (phy_addr == PXA168_ETH_PHY_ADDR_DEFAULT) {
- /* Scan entire range */
- start = ethernet_phy_get(pep);
- num = 32;
- } else {
- /* Use phy addr specific to platform */
- start = phy_addr & 0x1f;
- num = 1;
- }
- phydev = NULL;
- for (i = 0; i < num; i++) {
- int addr = (start + i) & 0x1f;
- if (bus->phy_map[addr] == NULL)
- mdiobus_scan(bus, addr);
-
- if (phydev == NULL) {
- phydev = bus->phy_map[addr];
- if (phydev != NULL)
- ethernet_phy_set_addr(pep, addr);
- }
- }
-
- return phydev;
-}
-
-static void phy_init(struct pxa168_eth_private *pep)
-{
- struct phy_device *phy = pep->phy;
-
- phy_attach(pep->dev, dev_name(&phy->dev), pep->phy_intf);
-
- phy->speed = pep->phy_speed;
- phy->duplex = pep->phy_duplex;
- phy->autoneg = AUTONEG_ENABLE;
- phy->supported &= PHY_BASIC_FEATURES;
- phy->advertising = phy->supported | ADVERTISED_Autoneg;
-
- if (pep->phy_speed != 0) {
- phy->autoneg = AUTONEG_DISABLE;
- phy->advertising = 0;
- }
-
- phy_start_aneg(phy);
-}
-
-static int ethernet_phy_setup(struct net_device *dev)
-{
- struct pxa168_eth_private *pep = netdev_priv(dev);
-
- pep->phy = phy_scan(pep, pep->phy_addr & 0x1f);
- if (pep->phy != NULL)
- phy_init(pep);
-
- update_hash_table_mac_address(pep, NULL, dev->dev_addr);
-
- return 0;
-}
-
static int pxa168_get_settings(struct net_device *dev, struct ethtool_cmd *cmd)
{
struct pxa168_eth_private *pep = netdev_priv(dev);
--
2.1.1
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
