Hi Maxime,
On Mon, 16 Feb 2015 13:51:11 +0100
Maxime Ripard <maxime.rip...@free-electrons.com> wrote:
> The NDDB register holds the data that are needed by the read and write
> commands.
>
> However, during a read PIO access, the datasheet specifies that after each 32
> bits read in that register, when BCH is enabled, we have to make sure that the
> RDDREQ bit is set in the NDSR register.
>
> This fixes an issue that was seen on the Armada 385, and presumably other
> mvebu
> SoCs, when a read on a newly erased page would end up in the driver reporting
> a
> timeout from the NAND.
>
> Cc: <sta...@vger.kernel.org> # v3.14
> Signed-off-by: Maxime Ripard <maxime.rip...@free-electrons.com>
> ---
> drivers/mtd/nand/pxa3xx_nand.c | 47
> ++++++++++++++++++++++++++++++++++++------
> 1 file changed, 41 insertions(+), 6 deletions(-)
>
> diff --git a/drivers/mtd/nand/pxa3xx_nand.c b/drivers/mtd/nand/pxa3xx_nand.c
> index 96b0b1d27df1..b2d8d6960765 100644
> --- a/drivers/mtd/nand/pxa3xx_nand.c
> +++ b/drivers/mtd/nand/pxa3xx_nand.c
> @@ -480,6 +480,41 @@ static void disable_int(struct pxa3xx_nand_info *info,
> uint32_t int_mask)
> nand_writel(info, NDCR, ndcr | int_mask);
> }
>
> +static void drain_fifo(struct pxa3xx_nand_info *info, void *data, int len)
> +{
> + if (info->ecc_bch) {
> + int index = 0;
> +
> + while (index < (len * 4)) {
> + u32 timeout;
> +
> + __raw_readsl(info->mmio_base + NDDB, data + index, 8);
> +
Shouldn't you break here if you've read all the data you were
expecting ?
As I said in my previous review, I don't know what's happening if you
wait for RDDREQ when the FIFO has been fully drained.
> + /*
> + * According to the datasheet, when reading
> + * from NDDB with BCH enabled, after each 32
> + * bytes reads, we have to make sure that the
> + * NDSR.RDDREQ bit is set
> + */
> + for (timeout = 0;
> + !(nand_readl(info, NDSR) & NDSR_RDDREQ);
> + timeout++) {
> + if (timeout >= 5) {
> + dev_err(&info->pdev->dev,
> + "Timeout on RDDREQ while
> draining the FIFO\n");
> + return;
> + }
> +
> + mdelay(1);
> + }
> +
> + index += 32;
> + }
> + } else {
> + __raw_readsl(info->mmio_base + NDDB, data, len);
> + }
> +}
Best Regards,
Boris
--
Boris Brezillon, Free Electrons
Embedded Linux and Kernel engineering
http://free-electrons.com
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
