Currently, a RCG's M/N counter (used for fraction division) is set to either
'bypass' (counter disabled) or 'dual edge' (counter enabled) based on whether
the corresponding rcg struct has a mnd field specified and a non-zero N.
In the case where M and N are the same value, the M/N counter is still enabled
by code even though no division takes place. Leaving the RCG in such a state
can result in improper behavior. This was observed with the DSI pixel clock RCG
when M and N were both set to 1.
Add an additional check (M != N) to enable the M/N counter only when it's needed
for fraction division.
Signed-off-by: Archit Taneja <arch...@codeaurora.org>
---
drivers/clk/qcom/clk-rcg2.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/clk/qcom/clk-rcg2.c b/drivers/clk/qcom/clk-rcg2.c
index 08b8b37..4fe9c01 100644
--- a/drivers/clk/qcom/clk-rcg2.c
+++ b/drivers/clk/qcom/clk-rcg2.c
@@ -242,7 +242,7 @@ static int clk_rcg2_configure(struct clk_rcg2 *rcg, const
struct freq_tbl *f)
mask |= CFG_SRC_SEL_MASK | CFG_MODE_MASK;
cfg = f->pre_div << CFG_SRC_DIV_SHIFT;
cfg |= rcg->parent_map[f->src] << CFG_SRC_SEL_SHIFT;
- if (rcg->mnd_width && f->n)
+ if (rcg->mnd_width && f->n && (f->m != f->n))
cfg |= CFG_MODE_DUAL_EDGE;
ret = regmap_update_bits(rcg->clkr.regmap,
rcg->cmd_rcgr + CFG_REG, mask, cfg);
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
hosted by The Linux Foundation
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
