> Message du 30/07/05 12:13 > De : "Francois Romieu" <[EMAIL PROTECTED]> [...] > Lars noticed that the link status is not correctly reported and suggested > a few changes. Can you check if the version below works better ? > I was precisely modifying mii_chip_table[] in sis190-120 to make it work ;-)
Yes, that new version works well. #dmesg sis190 Gigabit Ethernet driver 1.2 loaded. ACPI: PCI Interrupt 0000:00:04.0[A] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11 PCI: Setting latency timer of device 0000:00:04.0 to 64 0000:00:04.0: Read MAC address from APC. eth0: Realtek PHY RTL8201 transceiver at address 1. eth0: Using transceiver at address 1 as default. 0000:00:04.0: sis190 at ffffc20000004c00 (IRQ: 11), 00:11:2f:e9:42:70 eth0: Enabling Auto-negotiation. eth0: mii ext = 0000. eth0: mii lpa = c1e1 adv = 01e1. eth0: link on 100 Mbps Full Duplex mode. By the way, i still can not force speed/mode/autoneg (ethtool or mii-tool); ethtool reports correctly the changes, but autoneg is not really disabled, and the driver falls back to 100 Full... Had Lars better results with autoneg off? - Pascal - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/