Hi Nicholas, Thank you for the patch.
On Saturday 02 May 2015 09:57:07 Nicholas Mc Guire wrote: > wait_for_completion_timeout() returns unsigned long not int so the check > for <= should be == and the type unsigned long. With that fixup the return > value of flctl_dma_fifo0_transfer can be changed to 0 for success. This > changes the failure return value for wait_for_completion_timeout to > -ETIMEDOUT and implicitly 0 on success by initializing ret to 0. > The call-sites are fixed up to check for == 0 rather than > 0 as well. > > Signed-off-by: Nicholas Mc Guire <hof...@osadl.org> I would squash patches 3/4 and 4/4 into this one, there isn't much point in having indentation fixes as separate patches when this one already touches the same lines of code. Then, Acked-by: Laurent Pinchart <laurent.pinch...@ideasonboard.com> > --- > > V2: As suggested by Laurent Pinchart <laurent.pinch...@ideasonboard.com> > the expected success return value is 0 so rather than just fixing up > wait_for_completion_timeout return handling the return value of > flctl_dma_fifo0_transfer should be adjusted. > > call sites: > read_fiforeg,write_ec_fiforeg assume > 0 == success > are fixed up to check for == 0 for success > and the comment in flctl_dma_fifo0_transfe > /* ret > 0 is success */ > return ret; > is dropped since returning 0 on success is the expected. > > Patch was compile tested with ap325rxa_defconfig (implies > CONFIG_MTD_NAND_SH_FLCTL=y) > > Patch is against 4.1-rc1 (localversion-next is -next-20150501) > > drivers/mtd/nand/sh_flctl.c | 13 +++++++------ > 1 file changed, 7 insertions(+), 6 deletions(-) > > diff --git a/drivers/mtd/nand/sh_flctl.c b/drivers/mtd/nand/sh_flctl.c > index c3ce81c..9b032dd 100644 > --- a/drivers/mtd/nand/sh_flctl.c > +++ b/drivers/mtd/nand/sh_flctl.c > @@ -353,7 +353,8 @@ static int flctl_dma_fifo0_transfer(struct sh_flctl > *flctl, unsigned long *buf, dma_addr_t dma_addr; > dma_cookie_t cookie = -EINVAL; > uint32_t reg; > - int ret; > + int ret = 0; > + unsigned long time_left; > > if (dir == DMA_FROM_DEVICE) { > chan = flctl->chan_fifo0_rx; > @@ -388,13 +389,14 @@ static int flctl_dma_fifo0_transfer(struct sh_flctl > *flctl, unsigned long *buf, goto out; > } > > - ret = > + time_left = > wait_for_completion_timeout(&flctl->dma_complete, > msecs_to_jiffies(3000)); > > - if (ret <= 0) { > + if (time_left == 0) { > dmaengine_terminate_all(chan); > dev_err(&flctl->pdev->dev, "wait_for_completion_timeout\n"); > + ret = -ETIMEDOUT; > } > > out: > @@ -404,7 +406,6 @@ out: > > dma_unmap_single(chan->device->dev, dma_addr, len, dir); > > - /* ret > 0 is success */ > return ret; > } > > @@ -428,7 +429,7 @@ static void read_fiforeg(struct sh_flctl *flctl, int > rlen, int offset) > > /* initiate DMA transfer */ > if (flctl->chan_fifo0_rx && rlen >= 32 && > - flctl_dma_fifo0_transfer(flctl, buf, rlen, DMA_DEV_TO_MEM) > 0) > + flctl_dma_fifo0_transfer(flctl, buf, rlen, DMA_DEV_TO_MEM) == 0) > goto convert; /* DMA success */ > > /* do polling transfer */ > @@ -487,7 +488,7 @@ static void write_ec_fiforeg(struct sh_flctl *flctl, int > rlen, > > /* initiate DMA transfer */ > if (flctl->chan_fifo0_tx && rlen >= 32 && > - flctl_dma_fifo0_transfer(flctl, buf, rlen, DMA_MEM_TO_DEV) > 0) > + flctl_dma_fifo0_transfer(flctl, buf, rlen, DMA_MEM_TO_DEV) == 0) > return; /* DMA success */ > > /* do polling transfer */ -- Regards, Laurent Pinchart -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/