Hi, I will check code in several days, but I cannot re-produce a problem in a moment because I am away from home for business trip.
In my understand, the driver recognize the CPU properly. At Fri, 26 Aug 2005 19:01:37 +0100, Jose Miguel Goncalves wrote: > > Hi all, > > I'm trying to use cpufreq on my Geode GX1 board with linux-2.6.12.5, but, > while everything seems OK, i.e., I can change from performance to powersave > governor and back and /proc/cpuinfo reports me frequency changes, I can > get no effective frequency/CPU power change because I check it with > the Whetstone benchmark and it allways give me the same value (~100 MWIPS). > Any ideas from were could be the problem? Can you try to check also follows? /sys/devices/system/cpu/cpu0/cpufreq/scaling_cur_freq /sys/devices/system/cpu/cpu0/cpufreq/cpuinfo_cur_freq With this driver, it will significantly slow down by setting powersave mode. It seems some bus in the driver. Thank you for report. Hiroshi -- Hiroshi Miura --- [EMAIL PROTECTED], Mobile --- [EMAIL PROTECTED] NTTDATA Corp. OpenSource Software Center. --- [EMAIL PROTECTED] NTTDATA Intellilink Corp. OpenSource Engineering Dev. -- [EMAIL PROTECTED] Kobe Institute of Computing Graduate School of IT - Lecturer -- [EMAIL PROTECTED] Key id=04AB8617 fingerprint=9117 9407 5684 FBF1 4063 15B4 401D D077 04AB 8617 - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
