Tyler wrote:
Brett Russ wrote:
Some (non-functional) cleanup modifications since the version 0.10
driver I sent out 2005-08-30. Also adding signed-off-by for Jeff's
upstream push. This is my libata compatible low level driver for
the Marvell SATA family. Currently it successfully runs in PIO mode
on a 6081 chip. EDMA support is in the works and should be done
shortly. Review, testing (especially on other flavors of Marvell),
comments welcome.
Thank you,
BR
Signed-off-by: Brett Russ <[EMAIL PROTECTED]>
[snip..]
Please find attached patches that add the Adaptec 1420SA controller to
the PCI ID list in the driver, and a small note in the kernel config
option to state so. This is untested as of currently, if anyone has a
1420SA to try, that would be great.. The one I had access to is now
gone to a remote location out of reach for testing. I read in one post
I found with google, that the 1420SA uses a 6541 chip instead of a 6041,
but I am not able to verify this, and also don't know if it may still
work as a 6041. The card is still a Sata2, PCI-X card, with 4 ports,
the same as the 6041 based cards. This patch may or may not be
useful.. The card comes with a manufacturer ID of 9005 according to a
linux PCI-ID list, which is a secondary id of Adaptec's known as
ADAPTEC2, and an actual PCI Id of 0241.
I would prefer to have it tested, before accepting this patch...
Jeff
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/