On Fri, Oct 09, 2015 at 08:13:56PM +0800, Jisheng Zhang wrote: > On Fri, 9 Oct 2015 03:03:52 +0200 > Marcin Wojtas <m...@semihalf.com> wrote: > > > Marvell Armada 38x SDHCI controller enable using DAT3 pin as a hardware > > card detection. According to the SD sdandard this signal can be used for > > this purpose combined with a pull-up resistor, implying inverted (active > > low) polarization of a card detect. MMC standard does not support this > > feature and does not operate with such connectivity of DAT3. > > > > When using DAT3-based detection Armada 38x SDIO IP expects its internal > > clock to be always on, which had to be ensured twofold: > > What happen if runtime suspend disables its core clk and axi clk? I guess > dat3-based detection isn't compatible with runtime pm. If so, do we also > need to disable runtime pm in probe function? > > > - Each time controller is reset by updating appropriate registers. On the > > occasion of adding new register @0x104, register @0x100 name is modified > > in order to the be aligned with Armada 38x documentation. > > - Leaving the clock enabled despite power-down. For this purpose a new > > quirk had to be added to SDHCI subsystem - SDHCI_QUIRK2_KEEP_INT_CLK_ON. > > As seen from other mails, Ulf calls for no more quirks...
Absolutely. You have host->ops->set_clock, which you currently have set to sdhci_set_clock(). If you need to do something different, please replace that method with your own version - its fine to either wrap sdhci_set_clock() or replace it entirely. sdhci_set_clock() may benefit from being factored a little, so that it's easier to replace parts of it. -- FTTC broadband for 0.8mile line: currently at 9.6Mbps down 400kbps up according to speedtest.net. -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
