Hi,

I'm using Ubuntu 17.04 and I installed the ir-keytable tool. The
output of the ir-keytable command is as follows:



Found /sys/class/rc/rc0/ (/dev/input/event5) with:
Driver ite-cir, table rc-rc6-mce
Supported protocols: unknown other lirc rc-5 rc-5-sz jvc sony nec
sanyo mce_kbd rc-6 sharp xmp
Enabled protocols: lirc rc-6
Name: ITE8708 CIR transceiver
bus: 25, vendor/product: 1283:0000, version: 0x0000
Repeat delay = 500 ms, repeat period = 125 ms



I'm trying to enable the supported mce_kbd protocol in addition to the
lirc and rc-6 protocols with the

$ sudo ir-keytable -p lirc -p rc-6 -p mce_kbd

command which works as expected. If, however, I reboot my computer,
ir-keytable forgets this change and only the lirc and rc-6 protocols
are enabled. Is there a configuration file I can edit so that after
the boot my IR remote still works? Or is that so that the only way to
make it work is to write a start-up script that runs the above command
to enable the needed protocol?

Thank you in advance!

-- Szabolcs

Reply via email to