Hi Sören,
On Mon, Aug 28, 2017 at 06:40:25PM -0700, Soren Brinkmann wrote:
> From: Leon Luo <le...@leopardimaging.com>
>
> The binding file for imx274 CMOS sensor V4l2 driver
>
> Signed-off-by: Leon Luo <le...@leopardimaging.com>
> Acked-by: Sören Brinkmann <soren.brinkm...@xilinx.com>
> ---
> .../devicetree/bindings/media/i2c/imx274.txt | 32
> ++++++++++++++++++++++
> 1 file changed, 32 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/media/i2c/imx274.txt
>
> diff --git a/Documentation/devicetree/bindings/media/i2c/imx274.txt
> b/Documentation/devicetree/bindings/media/i2c/imx274.txt
> new file mode 100644
> index 000000000000..9154666d1149
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/media/i2c/imx274.txt
> @@ -0,0 +1,32 @@
> +* Sony 1/2.5-Inch 8.51Mp CMOS Digital Image Sensor
> +
> +The Sony imx274 is a 1/2.5-inch CMOS active pixel digital image sensor with
> +an active array size of 3864H x 2202V. It is programmable through I2C
> +interface. The I2C address is fixed to 0x1a as per sensor data sheet.
> +Image data is sent through MIPI CSI-2, which is configured as 4 lanes
> +at 1440 Mbps.
> +
> +
> +Required Properties:
> +- compatible: value should be "sony,imx274" for imx274 sensor
"reg"
> +
> +Optional Properties:
> +- reset-gpios: Sensor reset GPIO
> +
> +For further reading on port node refer to
> +Documentation/devicetree/bindings/media/video-interfaces.txt.
> +
> +Example:
> + imx274: sensor@1a{
Any use for the reference? If not, I'd omit it. For the endpoint you'll
need it.
> + compatible = "sony,imx274";
> + reg = <0x1a>;
> + #address-cells = <1>;
> + #size-cells = <0>;
> + reset-gpios = <&gpio_sensor 0 0>;
> + port@0 {
"@0" is redundant here, as is reg below.
> + reg = <0>;
> + sensor_out: endpoint {
> + remote-endpoint = <&csiss_in>;
> + };
> + };
> + };
--
Regards,
Sakari Ailus
e-mail: sakari.ai...@iki.fi
