On Thu, Mar 25, 2010 at 11:42:33AM -0300, Mauro Carvalho Chehab wrote: >> 2) add current_protocol support on other drivers; > > Done. Patch were already merged upstream. > > The current_protocol attribute shows the protocol(s) that the device is > accepting > and allows changing it to another protocol. > > In the case of the em28xx hardware, only one protocol can be active, since > the decoder > is inside the hardware. > > On the raw IR decode implementation I've done at the saa7134, all raw pulse > events are > sent to all registered decoders, so I'm thinking on using this sysfs node to > allow > disabling the standard behavior of passing the IR codes to all decoders, > routing it > to just one decoder. > > Another alternative would be to show current_protocol only for devices with > hardware > decoder, and create one sysfs node for each decoder, allowing > enabling/disabling each > decoder individually.
You're eventually going to want to add ioctl's to set a lot of TX or RX parameters in one go (stuff like active receiver(s) and transmitter(s), carrier frequency, duty cycle, timeouts, filter levels and resolution - all of which would need to be set in one operation since some hardware will need to be reset after each parameter is changed). Then you'll end up with a few things being controlled via sysfs and some being controlled via ioctls. Maybe it's a good idea to have a bitmask of supported and enabled protocols in those ioctls instead? -- David Härdeman -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
