On 06/05/2010 16:01, Thierry LELEGARD wrote:
I recently added a Hauppauge WinTV Nova-HD-S2 into a Linux system. I experience frequent packet loss and pci_abort errors. Each time my application detects packet loss (continuity errors actually), I get the following messages in dmesg: cx88[0]: irq mpeg [0x80000] pci_abort* cx88[0]/2-mpeg: general errors: 0x00080000 Such problems occur every few seconds. I use firmware file dvb-fe-cx24116.fw version 1.26.90.0. Since the IRQ was shared with the nVidia card and a Dektec modulator, I swapped some PCI boards. The IRQ is still shared but with another Tuner I do not use when using the S2 tuner. After swapping the PCI boards, the errors occur less frequently but still happen. Assuming that the pci_abort was due to an interrupted DMA transfer, I tried to increase the PCI latency timer of the device to 248 but this did not change anything (setpci -s 05:05 latency_timer=f8). I use the tuner with a custom application which reads the complete Transport stream. This application had worked for years using DVB-T and DVB-S tuners. I tried to reduce the application read buffer input size and it did not change anything at all. Note that my application still uses the V3 API, not the S2API. But, using DVB-S transponders, it works (except the pci_abort errors). I disabled the serial port, the parallel port and the PS/2 ports in the BIOS. It did not change anything either. Does anyone have an idea, please? Thanks a lot in advance for any help. -Thierry
I have the board working in a Ubuntu 9.10 system, log below shows no pci errors:
Apr 21 18:32:11 antec300 kernel: [ 16.576416] cx88/2: cx2388x MPEG-TS Driver Manager version 0.0.7 loaded Apr 21 18:32:11 antec300 kernel: [ 16.576711] cx88[0]: subsystem: 0070:6906, board: Hauppauge WinTV-HVR4000(Lite) DVB-S/S2 [card=69,autodetected], frontend(s): 1 Apr 21 18:32:11 antec300 kernel: [ 16.576714] cx88[0]: TV tuner type -1, Radio tuner type -1 Apr 21 18:32:11 antec300 kernel: [ 16.583565] cx88/0: cx2388x v4l2 driver version 0.0.7 loaded Apr 21 18:32:11 antec300 kernel: [ 16.586270] cx2388x alsa driver version 0.0.7 loaded Apr 21 18:32:11 antec300 kernel: [ 16.605679] EXT4-fs (sda1): internal journal on sda1:8 Apr 21 18:32:11 antec300 kernel: [ 16.755834] EXT4-fs (sdc1): barriers enabled Apr 21 18:32:11 antec300 kernel: [ 16.757791] kjournald2 starting: pid 956, dev sdc1:8, commit interval 5 seconds Apr 21 18:32:11 antec300 kernel: [ 16.763057] EXT4-fs (sdc1): internal journal on sdc1:8 Apr 21 18:32:11 antec300 kernel: [ 16.763061] EXT4-fs (sdc1): delayed allocation enabled Apr 21 18:32:11 antec300 kernel: [ 16.763063] EXT4-fs: file extents enabled Apr 21 18:32:11 antec300 kernel: [ 16.789147] EXT4-fs: mballoc enabled Apr 21 18:32:11 antec300 kernel: [ 16.789163] EXT4-fs (sdc1): mounted filesystem with ordered data mode Apr 21 18:32:11 antec300 kernel: [ 16.795868] tveeprom 2-0050: Hauppauge model 69100, rev B4C3, serial# 7084390 Apr 21 18:32:11 antec300 kernel: [ 16.795871] tveeprom 2-0050: MAC address is 00:0d:fe:6c:19:66 Apr 21 18:32:11 antec300 kernel: [ 16.795874] tveeprom 2-0050: tuner model is Conexant CX24118A (idx 123, type 4) Apr 21 18:32:11 antec300 kernel: [ 16.795876] tveeprom 2-0050: TV standards ATSC/DVB Digital (eeprom 0x80) Apr 21 18:32:11 antec300 kernel: [ 16.795878] tveeprom 2-0050: audio processor is None (idx 0) Apr 21 18:32:11 antec300 kernel: [ 16.795880] tveeprom 2-0050: decoder processor is CX880 (idx 20) Apr 21 18:32:11 antec300 kernel: [ 16.795882] tveeprom 2-0050: has no radio, has IR receiver, has no IR transmitter Apr 21 18:32:11 antec300 kernel: [ 16.795884] cx88[0]: hauppauge eeprom: model=69100 Apr 21 18:32:11 antec300 kernel: [ 16.798457] input: cx88 IR (Hauppauge WinTV-HVR400 as /devices/pci0000:00/0000:00:1e.0/0000:06:02.2/input/input6 Apr 21 18:32:11 antec300 kernel: [ 16.798488] cx88[0]/2: cx2388x 8802 Driver Manager Apr 21 18:32:11 antec300 kernel: [ 16.798500] cx88-mpeg driver manager 0000:06:02.2: PCI INT A -> GSI 19 (level, low) -> IRQ 19 Apr 21 18:32:11 antec300 kernel: [ 16.798506] cx88[0]/2: found at 0000:06:02.2, rev: 5, irq: 19, latency: 32, mmio: 0xf8000000 Apr 21 18:32:11 antec300 kernel: [ 16.798510] IRQ 19/cx88[0]: IRQF_DISABLED is not guaranteed on shared IRQs Apr 21 18:32:11 antec300 kernel: [ 16.799143] cx8800 0000:06:02.0: PCI INT A -> GSI 19 (level, low) -> IRQ 19 Apr 21 18:32:11 antec300 kernel: [ 16.799151] cx88[0]/0: found at 0000:06:02.0, rev: 5, irq: 19, latency: 32, mmio: 0xfa000000 Apr 21 18:32:11 antec300 kernel: [ 16.799158] IRQ 19/cx88[0]: IRQF_DISABLED is not guaranteed on shared IRQs Apr 21 18:32:11 antec300 kernel: [ 16.799193] cx88[0]/0: registered device video0 [v4l2] Apr 21 18:32:11 antec300 kernel: [ 16.799210] cx88[0]/0: registered device vbi0 Apr 21 18:32:11 antec300 kernel: [ 16.802095] cx88_audio 0000:06:02.1: PCI INT A -> GSI 19 (level, low) -> IRQ 19 Apr 21 18:32:11 antec300 kernel: [ 16.802102] IRQ 19/cx88[0]: IRQF_DISABLED is not guaranteed on shared IRQs Apr 21 18:32:11 antec300 kernel: [ 16.802122] cx88[0]/1: CX88x/0: ALSA support for cx2388x boards Apr 21 18:32:11 antec300 kernel: [ 17.166889] cx88/2: cx2388x dvb driver version 0.0.7 loaded Apr 21 18:32:11 antec300 kernel: [ 17.166893] cx88/2: registering cx8802 driver, type: dvb access: shared Apr 21 18:32:11 antec300 kernel: [ 17.166897] cx88[0]/2: subsystem: 0070:6906, board: Hauppauge WinTV-HVR4000(Lite) DVB-S/S2 [card=69] Apr 21 18:32:11 antec300 kernel: [ 17.166902] cx88[0]/2: cx2388x based DVB/ATSC card Apr 21 18:32:11 antec300 kernel: [ 17.166905] cx8802_alloc_frontends() allocating 1 frontend(s)
Not sure which .fw file was loaded (it just worked). If you would like further info let me know.
paul -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
