Hi Maxim,
on 31 Jul 10 at 01:01, Maxim Levitsky wrote:
> On Fri, 2010-07-30 at 23:22 +0200, Christoph Bartelmus wrote:
[...]
>>> +#define LIRC_SET_WIDEBAND_RECEIVER _IOW('i', 0x00000023, __u32)
>>
>> If you really want this new ioctl, then it should be clarified how it
>> behaves in relation to LIRC_SET_MEASURE_CARRIER_MODE.
> In my opinion, I won't need the LIRC_SET_MEASURE_CARRIER_MODE,
> I would just optionally turn that on in learning mode.
> You disagree, and since that is not important (besides TX and learning
> features are present only at fraction of ENE devices. The only user I
> did the debugging with, doesn't seem to want to help debug that code
> anymore...)
>
> But anyway, in current state I want these features to be independent.
> Driver will enable learning mode if it have to.
Please avoid the term "learning mode" as to you it probably means
something different than to me.
>
> I'll add the documentation.
>>
>> Do you have to enable the wide-band receiver explicitly before you can
>> enable carrier reports or does enabling carrier reports implicitly switch
>> to the wide-band receiver?
> I would implicitly switch the learning mode on, untill user turns off
> the carrier reports.
You mean that you'll implicitly switch on the wide-band receiver. Ok.
>>
>> What happens if carrier mode is enabled and you explicitly turn off the
>> wide-band receiver?
> Wouldn't it be better to have one ioctl for both after all?
There may be hardware that allows carrier measurement but does not have a
wide-band receiver. And there may be hardware that does have a wide-band
receiver but does not allow carrier measurement. irrecord needs to be able
to distinguish these cases, so we need separate ioctls.
I'd say: carrier reports may switch on the wide-band reciever implicitly.
In that case the wide-band receiver cannot be switched off explicitly
until carrier reports are disabled again. It just needs to be documented.
>>
>> And while we're at interface stuff:
>> Do we really need LIRC_SETUP_START and LIRC_SETUP_END? It is only used
>> once in lircd during startup.
> I don't think so.
>
Christoph
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
