On 04/06/2011 10:05 PM, Sylwester Nawrocki wrote: > Hi Pawel, > > On 03/07/2011 12:20 AM, Pawel Osciak wrote: >> Hi Laurent, >> >> On Tue, Mar 1, 2011 at 02:54, Laurent Pinchart >> <laurent.pinch...@ideasonboard.com> wrote: >>> Hi Pawel, >>> >>> On Monday 28 February 2011 16:44:38 Pawel Osciak wrote: >>>> Hi Laurent, >>>> A few questions from me below. I feel we need to talk about this >>>> change a bit more, it introduces some recovery and consistency >>>> problems, unless I'm missing something. >>>> >>>> On Sun, Feb 27, 2011 at 10:12, Laurent Pinchart wrote: >>>>> videobuf2 expects drivers to check buffer in the buf_prepare operation >>>>> and to return success only if the buffer can queued without any issue. >>>>> >>>>> For hot-pluggable devices, disconnection events need to be handled at >>>>> buf_queue time. Checking the disconnected flag and adding the buffer to >>>>> the driver queue need to be performed without releasing the driver >>>>> spinlock, otherwise race conditions can occur in which the driver could >>>>> still allow a buffer to be queued after the disconnected flag has been >>>>> set, resulting in a hang during the next DQBUF operation. >>>>> >>>>> This problem can be solved either in the videobuf2 core or in the device >>>>> drivers. To avoid adding a spinlock to videobuf2, make buf_queue return >>>>> an int and handle buf_queue failures in videobuf2. Drivers must not >>>>> return an error in buf_queue if the condition leading to the error can >>>>> be caught in buf_prepare. >>>>>
... > As buf_queue callback is called by vb2 only after start_streaming, > for a camera snapshot capture I needed to start a pipeline only from the > buf_queue handler level, i.e. subdev's video s_stream op was called from > within buf_queue. s_stream couldn't be done in the start_streaming handler > as at the time it is invoked there is always no buffer available in the > bridge H/W. > It's a consequence of how the vb2_streamon() is designed. > > Before, I used to simply call s_stream in start_streaming, only deferring > the actual bridge DMA enable till a buf_queue call, thus letting first frames > in the stream to be lost. This of course cannot be done in case of > single-frame > capture. > > To make a long story short, it would be useful in my case to have the ability > to return error codes as per VIDIOC_STREAMON through buf_queue in the driver > (when the first buffer is queued). > At the moment mainly EPIPE comes to my mind. This error code has no meaning > in the API for QBUF though. Should the pipeline be started from buf_queue Hmm, the pipeline validation could still be done in start_streaming() so we can return any EPIPE error from there directly and effectively in VIDIOC_STREAMON. So the only remaining errors are those related to I2C communication etc. when streaming is actually enabled in the subdev. > the errors from buf_queue would be seen in userspace via VIDIOC_STREAMON > and/or VIDIOC_QBUF. > > It should be also possible to signal any errors originating from the subdev > when s_stream is called on it, perhaps by EIO ? > ... -- Regards, Sylwester -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
