Jean-Christophe PLAGNIOL-VILLARD : >> + that embeds only one SD/MMC slot. >> + >> +config MACH_AT91SAM9G20EK_2MMC >> + bool "Atmel AT91SAM9G20-EK Evaluation Kit with 2 SD/MMC Slots" >> + depends on ARCH_AT91SAM9G20 >> + help >> + Select this if you are using an Atmel AT91SAM9G20-EK Evaluation Kit >> + with 2 SD/MMC Slots. This is the case for AT91SAM9G20-EK rev. C and >> + onwards. >> >> config MACH_CPU9G20 >> bool "Eukrea CPU9G20 board" >> @@ -392,7 +394,7 @@ config MTD_AT91_DATAFLASH_CARD >> >> config MTD_NAND_ATMEL_BUSWIDTH_16 >> bool "Enable 16-bit data bus interface to NAND flash" >> - depends on (MACH_AT91SAM9260EK || MACH_AT91SAM9261EK || >> MACH_AT91SAM9G10EK || MACH_AT91SAM9263EK || MACH_AT91SAM9G20EK || >> MACH_AT91SAM9G45EKES || MACH_AT91CAP9ADK) >> + depends on (MACH_AT91SAM9260EK || MACH_AT91SAM9261EK || >> MACH_AT91SAM9G10EK || MACH_AT91SAM9263EK || MACH_AT91SAM9G20EK || >> MACH_AT91SAM9G20EK_2MMC || MACH_AT91SAM9G45EKES || MACH_AT91CAP9ADK) > it's time to replace this by select it at machine config state
Ok patches are comming now on top of this one. >> @@ -254,7 +257,11 @@ static void __init ek_board_init(void) >> /* Ethernet */ >> at91_add_device_eth(&ek_macb_data); >> /* MMC */ >> +#if defined(CONFIG_MMC_ATMELMCI) || defined(CONFIG_MMC_ATMELMCI_MODULE) >> at91_add_device_mci(0, &ek_mmc_data); >> +#else >> + at91_add_device_mmc(0, &ek_mmc_data); >> +#endif > do we really need to do this choice at board level? Yes, you will choose on your board which driver will drive your sd/mmc interface. The device file will give access to both of them. Best regards, -- Nicolas Ferre -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
