MMC 4.4 Spec JEDEC Standard No. 84-A44 says CMD1 response from card has bit 30 set if card is high capacity. (page 111 - Section 8.1)
Toshiba flash <= 2GB has EXT_CSD sectors but does not support
High Capacity but because of bad test -- card was put into sector mode
causing failure.
Signed-off-by: Philip Rakity <prak...@marvell.com>
diff -ru linux-2.6.32.8/drivers/mmc/core/mmc.c linux-2.6.32.8
copy/drivers/mmc/core/mmc.c
--- linux-2.6.32.8/drivers/mmc/core/mmc.c 2010-02-09 04:57:19.000000000
-0800
+++ linux-2.6.32.8 copy/drivers/mmc/core/mmc.c 2010-03-11 14:15:03.000000000
-0800
@@ -221,8 +221,6 @@
ext_csd[EXT_CSD_SEC_CNT + 1] << 8 |
ext_csd[EXT_CSD_SEC_CNT + 2] << 16 |
ext_csd[EXT_CSD_SEC_CNT + 3] << 24;
- if (card->ext_csd.sectors)
- mmc_card_set_blockaddr(card);
}
switch (ext_csd[EXT_CSD_CARD_TYPE]) {
@@ -306,6 +304,7 @@
int err;
u32 cid[4];
unsigned int max_dtr;
+ u32 rocr;
BUG_ON(!host);
WARN_ON(!host->claimed);
@@ -319,7 +318,7 @@
mmc_go_idle(host);
/* The extra bit indicates that we support high capacity */
- err = mmc_send_op_cond(host, ocr | (1 << 30), NULL);
+ err = mmc_send_op_cond(host, ocr | MMC_CARD_SECTOR_ADDR, &rocr);
if (err)
goto err;
@@ -407,6 +406,9 @@
err = mmc_read_ext_csd(card);
if (err)
goto free_card;
+
+ if(rocr & MMC_CARD_SECTOR_ADDR)
+ mmc_card_set_blockaddr(card);
}
/*
diff -ru linux-2.6.32.8/include/linux/mmc/mmc.h linux-2.6.32.8
copy/include/linux/mmc/mmc.h
--- linux-2.6.32.8/include/linux/mmc/mmc.h 2010-02-09 04:57:19.000000000
-0800
+++ linux-2.6.32.8 copy/include/linux/mmc/mmc.h 2010-03-11 13:47:00.000000000
-0800
@@ -202,6 +202,7 @@
* OCR bits are mostly in host.h
*/
#define MMC_CARD_BUSY 0x80000000 /* Card Power up status bit */
+#define MMC_CARD_SECTOR_ADDR 0x40000000 /* Card supports sectors */
/*
* Card Command Classes (CCC)
eMMCHighCapacity.patch
Description: eMMCHighCapacity.patch
