This patch implements SDIO IRQ support for mfds which
announce the TMIO_MMC_SDIO_IRQ flag for tmio_mmc.
If MMC_CAP_SDIO_IRQ is also set SDIO IRQ signalling is activated.
Tested with a b43-based wireless SDIO card and sh_mobile_sdhi.
This patch applies on top of:
mmc: tmio_mmc: allow multi-element scatter-gather lists
mmc: tmio_mmc: fix PIO fallback on DMA descriptor allocation failure
mmc: tmio: merge the private header into the driver
mmc: tmio: implement a bounce buffer for unaligned DMA
Signed-off-by: Arnd Hannemann <a...@arndnet.de>
---
Changes in v2:
- added TMIO_MMC_SDIO_IRQ flag to support the case where SDIO IRQ
interrupts are generated but SDIO IRQ signalling to the core
should not be used
- rearranged code, so that either an SDIO IRQ or a normal IRQ is
handled, this marginally increases interrupt load, but preserves
the current timing, which seems to be crucial for DMA handling
drivers/mmc/host/tmio_mmc.c | 61 ++++++++++++++++++++++++++++++++++++++++++-
include/linux/mfd/tmio.h | 4 +++
2 files changed, 64 insertions(+), 1 deletions(-)
diff --git a/drivers/mmc/host/tmio_mmc.c b/drivers/mmc/host/tmio_mmc.c
index 57ece9d..18771b4 100644
--- a/drivers/mmc/host/tmio_mmc.c
+++ b/drivers/mmc/host/tmio_mmc.c
@@ -53,6 +53,8 @@
#define CTL_SD_ERROR_DETAIL_STATUS 0x2c
#define CTL_SD_DATA_PORT 0x30
#define CTL_TRANSACTION_CTL 0x34
+#define CTL_SDIO_STATUS 0x36
+#define CTL_SDIO_IRQ_MASK 0x38
#define CTL_RESET_SD 0xe0
#define CTL_SDIO_REGS 0x100
#define CTL_CLK_AND_WAIT_CTL 0x138
@@ -81,6 +83,12 @@
#define TMIO_STAT_CMD_BUSY 0x40000000
#define TMIO_STAT_ILL_ACCESS 0x80000000
+/* Definitions for values the CTRL_SDIO_STATUS register can take. */
+#define TMIO_SDIO_STAT_IOIRQ 0x0001
+#define TMIO_SDIO_STAT_EXPUB52 0x4000
+#define TMIO_SDIO_STAT_EXWT 0x8000
+#define TMIO_SDIO_MASK_ALL 0xc007
+
/* Define some IRQ masks */
/* This is the mask used at reset by the chip */
#define TMIO_MASK_ALL 0x837f031d
@@ -122,6 +130,7 @@ struct tmio_mmc_host {
struct mmc_data *data;
struct mmc_host *mmc;
int irq;
+ unsigned int sdio_irq_enabled;
/* Callbacks for clock / power control */
void (*set_pwr)(struct platform_device *host, int state);
@@ -247,6 +256,22 @@ void pr_debug_status(u32 status)
#define pr_debug_status(s) do { } while (0)
#endif
+static void tmio_mmc_enable_sdio_irq(struct mmc_host *mmc, int enable)
+{
+ struct tmio_mmc_host *host = mmc_priv(mmc);
+
+ if (enable) {
+ host->sdio_irq_enabled = 1;
+ sd_ctrl_write16(host, CTL_TRANSACTION_CTL, 0x0001);
+ sd_ctrl_write16(host, CTL_SDIO_IRQ_MASK,
+ (TMIO_SDIO_MASK_ALL & ~TMIO_SDIO_STAT_IOIRQ));
+ } else {
+ sd_ctrl_write16(host, CTL_SDIO_IRQ_MASK, TMIO_SDIO_MASK_ALL);
+ sd_ctrl_write16(host, CTL_TRANSACTION_CTL, 0x0000);
+ host->sdio_irq_enabled = 0;
+ }
+}
+
static void tmio_mmc_set_clock(struct tmio_mmc_host *host, int new_clock)
{
u32 clk = 0, clock;
@@ -275,10 +300,16 @@ static void tmio_mmc_clk_stop(struct tmio_mmc_host *host)
static void tmio_mmc_clk_start(struct tmio_mmc_host *host)
{
+ struct mfd_cell *cell = host->pdev->dev.platform_data;
+ struct tmio_mmc_data *pdata = cell->driver_data;
+
sd_ctrl_write16(host, CTL_SD_CARD_CLK_CTL, 0x0100 |
sd_ctrl_read16(host, CTL_SD_CARD_CLK_CTL));
msleep(10);
sd_ctrl_write16(host, CTL_CLK_AND_WAIT_CTL, 0x0100);
+ /* restore sdio irq state */
+ if (pdata->flags & TMIO_MMC_SDIO_IRQ)
+ tmio_mmc_enable_sdio_irq(host->mmc, host->sdio_irq_enabled);
msleep(10);
}
@@ -556,7 +587,10 @@ static void tmio_mmc_cmd_irq(struct tmio_mmc_host *host,
static irqreturn_t tmio_mmc_irq(int irq, void *devid)
{
struct tmio_mmc_host *host = devid;
+ struct mfd_cell *cell = host->pdev->dev.platform_data;
+ struct tmio_mmc_data *pdata = cell->driver_data;
unsigned int ireg, irq_mask, status;
+ unsigned int sdio_ireg, sdio_irq_mask, sdio_status;
pr_debug("MMC IRQ begin\n");
@@ -564,10 +598,33 @@ static irqreturn_t tmio_mmc_irq(int irq, void *devid)
irq_mask = sd_ctrl_read32(host, CTL_IRQ_MASK);
ireg = status & TMIO_MASK_IRQ & ~irq_mask;
+ sdio_ireg = 0;
+ if (!ireg && pdata->flags & TMIO_MMC_SDIO_IRQ) {
+ sdio_status = sd_ctrl_read16(host, CTL_SDIO_STATUS);
+ sdio_irq_mask = sd_ctrl_read16(host, CTL_SDIO_IRQ_MASK);
+ sdio_ireg = sdio_status & TMIO_SDIO_MASK_ALL & ~sdio_irq_mask;
+
+ sd_ctrl_write16(host, CTL_SDIO_STATUS, sdio_status &
~TMIO_SDIO_MASK_ALL);
+
+ if (sdio_ireg && !host->sdio_irq_enabled) {
+ pr_warning("tmio_mmc: Spurious SDIO IRQ, disabling!
0x%04x 0x%04x 0x%04x\n",
+ sdio_status, sdio_irq_mask, sdio_ireg);
+ tmio_mmc_enable_sdio_irq(host, 0);
+ goto out;
+ }
+
+ if (host->mmc->caps & MMC_CAP_SDIO_IRQ &&
+ sdio_ireg & TMIO_SDIO_STAT_IOIRQ)
+ mmc_signal_sdio_irq(host->mmc);
+
+ if (sdio_ireg)
+ goto out;
+ }
+
pr_debug_status(status);
pr_debug_status(ireg);
if (!ireg) {
disable_mmc_irqs(host, status & ~irq_mask);
pr_warning("tmio_mmc: Spurious irq, disabling! "
@@ -1033,6 +1089,7 @@ static const struct mmc_host_ops tmio_mmc_ops = {
.set_ios = tmio_mmc_set_ios,
.get_ro = tmio_mmc_get_ro,
.get_cd = tmio_mmc_get_cd,
+ .enable_sdio_irq = tmio_mmc_enable_sdio_irq,
};
#ifdef CONFIG_PM
@@ -1147,6 +1204,8 @@ static int __devinit tmio_mmc_probe(struct
platform_device *dev)
goto cell_disable;
disable_mmc_irqs(host, TMIO_MASK_ALL);
+ if (pdata->flags & TMIO_MMC_SDIO_IRQ)
+ tmio_mmc_enable_sdio_irq(mmc, 0);
ret = request_irq(host->irq, tmio_mmc_irq, IRQF_DISABLED |
IRQF_TRIGGER_FALLING, dev_name(&dev->dev), host);
diff --git a/include/linux/mfd/tmio.h b/include/linux/mfd/tmio.h
index dbfc053..8e70310 100644
--- a/include/linux/mfd/tmio.h
+++ b/include/linux/mfd/tmio.h
@@ -57,6 +57,10 @@
* is configured in 4-bit mode.
*/
#define TMIO_MMC_BLKSZ_2BYTES (1 << 1)
+/*
+ * Some controllers can support SDIO IRQ signalling.
+ */
+#define TMIO_MMC_SDIO_IRQ (1 << 2)
int tmio_core_mmc_enable(void __iomem *cnf, int shift, unsigned long base);
int tmio_core_mmc_resume(void __iomem *cnf, int shift, unsigned long base);
--
1.7.2.3
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
