Hi, On Thu, Nov 01, 2012 at 01:21:36AM +0530, Venkatraman S wrote: > On Wed, Oct 31, 2012 at 5:56 PM, Felipe Balbi <ba...@ti.com> wrote: > > Hi, > > > > On Wed, Oct 31, 2012 at 05:27:36PM +0530, Hebbar, Gururaja wrote: > >> HSMMC IP on AM33xx need a special setting to handle High-speed cards. > >> Other platforms like TI81xx, OMAP4 may need this as-well. This depends > >> on the HSMMC IP timing closure done for the high speed cards. > >> > >> From AM335x TRM (SPRUH73F - 18.3.12 Output Signals Generation) > >> > >> The MMC/SD/SDIO output signals can be driven on either falling edge or > >> rising edge depending on the SD_HCTL[2] HSPE bit. This feature allows > >> to reach better timing performance, and thus to increase data transfer > >> frequency. > >> > >> There are few pre-requisites for enabling the HSPE bit > >> - Controller should support High-Speed-Enable Bit and > >> - Controller should not be using DDR Mode and > >> - Controller should advertise that it supports High Speed in > >> capabilities register and > >> - MMC/SD clock coming out of controller > 25MHz > >> > >> Note: > >> The implementation reuses the output of calc_divisor() so as to reduce > >> code addition. > >> > >> Signed-off-by: Hebbar, Gururaja <gururaja.heb...@ti.com> > > > > this looks good to my eyes, hopefully I haven't missed anything: > > > > Reviewed-by: Felipe Balbi <ba...@ti.com> > > > > Except for the excessively verbose comments which are just duplicating the > code, > <Quote> > >> + * Enable High-Speed Support > >> + * Pre-Requisites > >> + * - Controller should support High-Speed-Enable Bit > >> + * - Controller should not be using DDR Mode > >> + * - Controller should advertise that it supports High Speed > >> + * in capabilities register > >> + * - MMC/SD clock coming out of controller > 25MHz > >> + */ > </Quote> > > I'm ok with this patch as well. I'm putting a few patches under test > including this one, > and will send it to Chris as part of that series. > I'll strip out the above mentioned comments, unless there are any > objections.
please don't. Detailing the pre-requisites for getting HSP mode working isn't bad at all. Should someone decide to change the behavior and ends up breaking it, the comment will help putting things back together. my 2 cents, you've got the final decision though. -- balbi
signature.asc
Description: Digital signature
