From: Dirk Behme <dirk.be...@de.bosch.com>
The commit ad93220de7da ("mmc: sdhci-esdhc-imx: change pinctrl state
according to uhs mode") exits the probe in case there are no valid
pinctrl states found.
As there are configurations doing the pin mux properly in the boot
loader, don't exit. Just warn, but go on in case if there are no
pinctrl states in the device tree.
Signed-off-by: Dirk Behme <dirk.be...@de.bosch.com>
Signed-off-by: Andrew Gabbasov <andrew_gabba...@mentor.com>
---
drivers/mmc/host/sdhci-esdhc-imx.c | 7 +++----
1 file changed, 3 insertions(+), 4 deletions(-)
diff --git a/drivers/mmc/host/sdhci-esdhc-imx.c
b/drivers/mmc/host/sdhci-esdhc-imx.c
index ccec0e3..b714b9d 100644
--- a/drivers/mmc/host/sdhci-esdhc-imx.c
+++ b/drivers/mmc/host/sdhci-esdhc-imx.c
@@ -1012,9 +1012,7 @@ static int sdhci_esdhc_imx_probe(struct platform_device
*pdev)
imx_data->pins_default = pinctrl_lookup_state(imx_data->pinctrl,
PINCTRL_STATE_DEFAULT);
if (IS_ERR(imx_data->pins_default)) {
- err = PTR_ERR(imx_data->pins_default);
- dev_err(mmc_dev(host->mmc), "could not get default state\n");
- goto disable_clk;
+ dev_warn(mmc_dev(host->mmc), "could not get default state\n");
}
host->quirks |= SDHCI_QUIRK_BROKEN_TIMEOUT_VAL;
@@ -1103,7 +1101,8 @@ static int sdhci_esdhc_imx_probe(struct platform_device
*pdev)
}
/* sdr50 and sdr104 needs work on 1.8v signal voltage */
- if ((boarddata->support_vsel) && esdhc_is_usdhc(imx_data)) {
+ if ((boarddata->support_vsel) && esdhc_is_usdhc(imx_data) &&
+ !IS_ERR(imx_data->pins_default)) {
imx_data->pins_100mhz = pinctrl_lookup_state(imx_data->pinctrl,
ESDHC_PINCTRL_STATE_100MHZ);
imx_data->pins_200mhz = pinctrl_lookup_state(imx_data->pinctrl,
--
2.1.0
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
