mmc_do_hw_reset(), mmc_power_up() and mmc_power_off() all set similar
initial values for bus_mode, bus_width, chip_select and timing. Let's
make this handling simpler and more consistent by sticking them
together in a common function. This will introduce small changes in
behavior in the following places:
mmc_power_off():
For SPI hosts, explicitly set bus_mode = MMC_BUSMODE_PUSHPULL and
chip_select = MMC_CS_HIGH, before we left them as they were.
For non-SPI hosts, set bus_mode = MMC_BUSMODE_PUSHPULL instead of
MMC_BUSMODE_OPENDRAIN as before.
These two changes should not be a problem since the device will be
powered off anyway.
mmc_do_hw_reset():
Always set bus_mode = MMC_BUSMODE_PUSHPULL, as required by SD/SDIO
cards. MMC cards require MMC_BUSMODE_OPENDRAIN, but this is taken
care of by mmc_init_card() and mmc_attach_mmc().
Signed-off-by: Johan Rudholm <joha...@axis.com>
---
drivers/mmc/core/core.c | 47 ++++++++++++++++++++++-------------------------
drivers/mmc/core/core.h | 1 +
2 files changed, 23 insertions(+), 25 deletions(-)
diff --git a/drivers/mmc/core/core.c b/drivers/mmc/core/core.c
index a32bea2..5bda29b 100644
--- a/drivers/mmc/core/core.c
+++ b/drivers/mmc/core/core.c
@@ -1099,6 +1099,22 @@ void mmc_set_bus_width(struct mmc_host *host, unsigned
int width)
mmc_host_clk_release(host);
}
+/*
+ * Set initial state after a power cycle or a hw_reset.
+ */
+void mmc_set_initial_state(struct mmc_host *host)
+{
+ if (mmc_host_is_spi(host))
+ host->ios.chip_select = MMC_CS_HIGH;
+ else
+ host->ios.chip_select = MMC_CS_DONTCARE;
+ host->ios.bus_mode = MMC_BUSMODE_PUSHPULL;
+ host->ios.bus_width = MMC_BUS_WIDTH_1;
+ host->ios.timing = MMC_TIMING_LEGACY;
+
+ mmc_set_ios(host);
+}
+
/**
* mmc_vdd_to_ocrbitnum - Convert a voltage to the OCR bit number
* @vdd: voltage (mV)
@@ -1537,15 +1553,9 @@ void mmc_power_up(struct mmc_host *host, u32 ocr)
mmc_host_clk_hold(host);
host->ios.vdd = fls(ocr) - 1;
- if (mmc_host_is_spi(host))
- host->ios.chip_select = MMC_CS_HIGH;
- else
- host->ios.chip_select = MMC_CS_DONTCARE;
- host->ios.bus_mode = MMC_BUSMODE_PUSHPULL;
host->ios.power_mode = MMC_POWER_UP;
- host->ios.bus_width = MMC_BUS_WIDTH_1;
- host->ios.timing = MMC_TIMING_LEGACY;
- mmc_set_ios(host);
+ /* Set initial state and call mmc_set_ios */
+ mmc_set_initial_state(host);
/* Try to set signal voltage to 3.3V but fall back to 1.8v or 1.2v */
if (__mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_330) == 0)
@@ -1585,14 +1595,9 @@ void mmc_power_off(struct mmc_host *host)
host->ios.clock = 0;
host->ios.vdd = 0;
- if (!mmc_host_is_spi(host)) {
- host->ios.bus_mode = MMC_BUSMODE_OPENDRAIN;
- host->ios.chip_select = MMC_CS_DONTCARE;
- }
host->ios.power_mode = MMC_POWER_OFF;
- host->ios.bus_width = MMC_BUS_WIDTH_1;
- host->ios.timing = MMC_TIMING_LEGACY;
- mmc_set_ios(host);
+ /* Set initial state and call mmc_set_ios */
+ mmc_set_initial_state(host);
/*
* Some configurations, such as the 802.11 SDIO card in the OLPC
@@ -2278,16 +2283,8 @@ static int mmc_do_hw_reset(struct mmc_host *host, int
check)
}
}
- if (mmc_host_is_spi(host)) {
- host->ios.chip_select = MMC_CS_HIGH;
- host->ios.bus_mode = MMC_BUSMODE_PUSHPULL;
- } else {
- host->ios.chip_select = MMC_CS_DONTCARE;
- host->ios.bus_mode = MMC_BUSMODE_OPENDRAIN;
- }
- host->ios.bus_width = MMC_BUS_WIDTH_1;
- host->ios.timing = MMC_TIMING_LEGACY;
- mmc_set_ios(host);
+ /* Set initial state and call mmc_set_ios */
+ mmc_set_initial_state(host);
mmc_host_clk_release(host);
diff --git a/drivers/mmc/core/core.h b/drivers/mmc/core/core.h
index 443a584..d76597c 100644
--- a/drivers/mmc/core/core.h
+++ b/drivers/mmc/core/core.h
@@ -49,6 +49,7 @@ void mmc_set_driver_type(struct mmc_host *host, unsigned int
drv_type);
void mmc_power_up(struct mmc_host *host, u32 ocr);
void mmc_power_off(struct mmc_host *host);
void mmc_power_cycle(struct mmc_host *host, u32 ocr);
+void mmc_set_initial_state(struct mmc_host *host);
static inline void mmc_delay(unsigned int ms)
{
--
1.7.2.5
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
