Guys,
I have a 486 running Slackware 3.6 (2.0.35) with an SMC 1660BT ISA
Ethernet card. It is a jumperless card. Booting off a DOS floppy and
using the SMC setup disk, I set the IRQ to 10, which doesn't conflict with
anything else.
For some reason, the card is being assigned IRQ 3 which is conflicting
with my serial port. I tried to manually assign the IRQ at the lilo
prompt, but it didn't take the change (as in the Ethernet-HOWTO).
Also, I tried to add this line (ether=10,0,0,0,eth0) into my lilo.conf
file, but it came back with an error.
Here is a some of the startup info:
.
tty00 at 0x03f8 (irq = 4) is a 16450
tty01 at 0x02f8 (irq = 3) is a 16450
.
wd.c:v1.10 9/23/94 Donald Becker ([EMAIL PROTECTED])
eth0: WD80x3 at 0x280, 00 00 C0 32 E1 1A assigning address 0xd0000 \
WD8003-old, IRQ 3, shared memory at 0xd0000-0xd1fff.
Thanks,
Mark
--
Mark Riehl
The MITRE Corporation
[EMAIL PROTECTED]
-
To unsubscribe from this list: send the line "unsubscribe linux-net" in
the body of a message to [EMAIL PROTECTED]
