On Tue, 16 Feb 1999, BOSMANS Peter wrote:
> Am i at the right place, if not , show me the way please.
> I have two exactly tesame network-cards installed in my linux-box
> (3C509B-TPO 3COM etherlink III).
> There are no jumpers on the card.
> I've added the next line in lilo.conf : append="ether=0,0,eth1" then do
> /sbin/lilo
_________________________________________________________
***try append ="ether=10,0xff80,eth0 ether=9,0xff40,eth1"
_________________________________________________________
> When i reboot. None of the 2 cards come in active state.
> In de boot-messages (dmesg), I see that de IO-adress is tesame for the 2
> cards (300) and the IRQ (10) too.
> That will probably the problem, but i don't know how to change it. (Because
> there are no jumpers on the ethernet card)
______________________________________________________________
do scanpci....it will give u which irq lines are attached to unknown
devices..then u can force those base addresses to the devices in ypur
append line
-------------------------------------------------------------------- > Can
somebody help me ?
> Thanks in advance.
>
> greetings,
>
> Peter Bosmans
>
>
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-net" in
> the body of a message to [EMAIL PROTECTED]
>
[31m Indifference will certainly be the downfall of mankind,but who cares??
4m
[4m [36m Siddhartha Srivastava
[36m dept. of Electrical Engineering,
[32m Indian Institute Of Science,
[33m Bangalore.
3 Hostel Addr.
3 M-50. [0m
-
To unsubscribe from this list: send the line "unsubscribe linux-net" in
the body of a message to [EMAIL PROTECTED]
